CARDONE Reman Mass Air Flow Sensor P/N:74-50047
A1 CARDONE 74-10035 mass air flow sensor for the 1995-1999 Nissan Maxima V6 3.0L and other vehicles measures incoming air for the engine control system. This remanufactured unit tracks O.E. output curves and holds spec tolerances.
Hesitation, stalling, poor fuel economy or poor engine performance can come from a faulty mass air flow sensor, though other parts can produce them as well. Before replacing it, look over the sensor element with the engine off for damage or a burnt smell; a shop can read the trouble codes and test it.
The 1995-1999 Nissan Maxima V6 3.0L, the 1996-2001 Infiniti I30 V6 3.0L and the 1997-2001 Infiniti Q45 V8 4.1L all take this mass air flow sensor, and it fits more vehicles besides.
Fit and size
Build and materials
One mass air flow sensor and one instruction sheet. This listing holds one sensor, and one is all the engine takes. Mounting hardware, a mounting bracket and a wiring harness are not included, so plan on new bolts and clamp hardware rather than reusing the old ones.
Interchange: 2268031U00 · 2268031U05
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is the A1 CARDONE 74-10035 the right maf sensor for the 1995-1999 Nissan Maxima V6 3.0L?
Yes. A1 CARDONE 74-10035 fits the 1995-1999 Nissan Maxima V6 3.0L. If your car is a different model, look it up in the Vehicles it fits section on this page.
Does this mass air flow sensor for the 1995-1999 Nissan Maxima V6 3.0L also work on the 1997-2001 Infiniti Q45 V8 4.1L?
Yes. A1 CARDONE 74-10035 fits the 1997-2001 Infiniti Q45 V8 4.1L as well as the 1995-1999 Nissan Maxima V6 3.0L.
Does the A1 CARDONE 74-10035 come with a wiring harness or mounting bracket?
No. The box holds one mass air flow sensor and an instruction sheet. Mounting hardware, a mounting bracket and a wiring harness are not included.
What outlet diameter and connector does this mass air flow sensor have?
The outlet connection diameter is 66.15 mm (2.7 in). The single rectangular connector is male, with 3 male pin terminals.
What usually fails inside a bad mass air flow sensor?
Common causes are cracked circuit boards, burnt sensing elements, poor solder joints, deteriorated conformal coating and loose circuit board components. This unit has 100% re-soldering of critical components.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.