CARDONE Reman Mass Air Flow Sensor P/N:74-50048
A1 CARDONE 74-7539 mass air flow sensor for the 1985-1988 Buick Century V6 3.8L and other vehicles reports the air entering the engine to the engine control system. This remanufactured A1 CARDONE mass air flow sensor tracks O.E. output curves and holds spec tolerances for accurate scan tool readings.
A failing mass air flow sensor can show up as hesitation, stalling, poor fuel economy or poor engine performance. Before you replace the sensor, rule out the intake duct, the wiring and the connector by looking them over with the engine off and having trouble codes read with a scanner.
This sensor is listed for a wide range of Buick and Oldsmobile models, including the 1985-1988 Oldsmobile Cutlass Ciera V6 3.8L and the 1987-1988 Oldsmobile Cutlass Cruiser V6 3.8L. The quantity per vehicle is one.
Fit and size
Build and materials
One mass air flow sensor and one instruction sheet. Mounting hardware, mounting bracket and wiring harness are not included; plan on new fasteners, since the old ones may not be reusable.
Interchange: 25007539 · 25007872
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is the A1 CARDONE 74-7539 a Buick Century mass air flow sensor for the 1985-1988 Century V6 3.8L?
Yes. A1 CARDONE 74-7539 is listed for the 1985-1988 Buick Century V6 3.8L. For a different model, look up your car in the "Vehicles it fits" section on this product page.
Does this mass air flow sensor come with a wiring harness or mounting bracket?
No. The listing is one remanufactured sensor and an instruction sheet. Mounting hardware, the mounting bracket and the wiring harness are not included.
How many terminals does the connector on the 74-7539 sensor have?
A1 CARDONE 74-7539 has one rectangular male connector with three male pin terminals. The sensor housing is plastic.
How can I tell if my mass air flow sensor is going bad?
Hesitation, stalling, poor fuel economy or poor engine performance can be signs of a malfunctioning sensor. With the engine off, look at the sensor element for damage or a burnt smell, and have a scanner read for trouble codes.
How is this remanufactured mass air flow sensor tested?
Critical components are 100% re-soldered, and every module is 100% tested with automated computer test equipment. On-car vehicle validation routines also check form, fit, durability and performance.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.