CARDONE Reman Mass Air Flow Sensor P/N:74-10053
A1 CARDONE 74-9525 mass air flow sensor for the 1996 Ford F-250 6-cylinder 4.9L or V8 5.0L, the 1996-1997 F-250 V8 5.8L and other vehicles measures the air entering the engine and reports it to the engine control system. This remanufactured sensor tracks O.E. output curves to give accurate air-flow feedback.
A failing mass air flow sensor can bring hesitation, stalling, poor fuel economy or poor engine performance. These signs alone do not prove the sensor is the problem; a vacuum leak is another common cause.
This mass air flow sensor is listed for a wide range of Ford, Lincoln and Mercury models, including the 1996 Ford F-150 6-cylinder 4.9L, V8 5.0L or 5.8L and the 1996 Ford Bronco V8 5.0L or 5.8L. This listing is one sensor, and the 1996-1997 Ford F-250 V8 5.8L takes one.
Fit and size
Build and materials
One mass air flow sensor and one instruction sheet. Mounting hardware, a mounting bracket and a wiring harness are not included, and old hardware may not be reusable, so plan on new pieces where needed.
Interchange: F5UF12B579BA · F5UZ12B579BA · F5VF12B579BA · F5VY12B579B
This part cross-references / interchanges with the following part numbers:
Is this the right mass air flow sensor for a 1996 Ford F-150 with the 6-cylinder 4.9L, V8 5.0L or 5.8L engine?
Yes, A1 CARDONE 74-9525 is listed for the 1996 Ford F-150 6-cylinder 4.9L, V8 5.0L or 5.8L. If your vehicle is not named on this page, look it up in the "Vehicles it fits" section.
Does this mass air flow sensor come with a wiring harness or mounting bracket?
No. The box holds the mass air flow sensor and an instruction sheet; the mounting hardware, bracket and wiring harness are not included.
What does the re-soldering on this A1 CARDONE mass air flow sensor do?
A1 CARDONE 74-9525 has 100% of its critical components re-soldered, which is intended to give solid electrical connections and avoid intermittent failures. Each unit is also tested on automated computer equipment.
What size is the outlet connection on this mass air flow sensor?
The outlet connection diameter is 80.85 mm (3.3 in). The sensor mounts with four mounting holes and a hose clamp, and has one rectangular connector with four male pin terminals.
How do I check whether a mass air flow sensor is bad?
With the engine off and cool, look at the sensor element for damage or a burnt smell, and have the vehicle scanned for trouble codes. Cracked circuit boards, burnt sensing elements and poor solder joints are common causes of failure.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.