Stay ahead of worn rear brake pads with the Carlson Disc Brake Pad Electronic Wear Sensor 19100. This rear-position electronic wear sensor installs as a direct-fit replacement for the 2013-2015 BMW X1 [All], wiring into the brake pad circuit so it can signal the driver when the pads reach their wear limit.
It terminates in a single female connector with one male pin terminal on a 45-inch wiring harness. The listed BMW X1 application uses two sensors; it's sold individually, so order the quantity your vehicle requires. Country of origin: China.
Interchange: FH19100 · Manufacturer part number 19100
This part cross-references / interchanges with the following part numbers:
What does this part do?
It's an electronic brake pad wear sensor. As the rear pads wear down the sensor frays, signaling the driver that the brake pads and hardware need to be replaced.
What vehicle does it fit?
It's a direct-fit replacement for the 2013-2015 BMW X1 [All]. Check the Buyer's Guide tab to confirm the fit for your vehicle.
Can I reuse the old sensor?
No. This wear sensor cannot be reused once the brake pads are replaced — install a new one with each pad service.
How many sensors do I need?
The listed BMW X1 application uses two sensors. It's sold individually, so order the quantity your vehicle requires.
What are the connector details?
It has a single female connector with one male pin terminal on a 45-inch (45 IN) wiring harness.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
