MOOG Chassis Products Suspension Control Arm and Ball Joint Assembly P/N:RK624114
$98.99
(You save)
Replace a worn control arm and its integrated ball joint in one bolt-in unit with the MOOG RK624114 Suspension Control Arm and Ball Joint Assembly. This is the front left lower forward control arm and ball joint assembly, and it drops in as a direct-fit replacement for the 2014-2023 Tesla S and 2016-2023 Tesla X. See the Buyer's Guide tab to confirm your specific vehicle.
Carbon-fiber-reinforced bearing: works with induction-hardened studs to reduce socket friction versus non-reinforced bearings, helping extend socket life.
Induction-hardened studs: hardened to maximize strength, resist breakage, and improve fatigue life.
Pre-installed dust boot seal: forms a barrier that helps keep dirt and water out to limit wear-causing contamination.
Corrosion-inhibiting coatings: applied to metal surfaces to help slow deterioration from rain, snow, salt, and road grime.
Premium bushings & hardware: pre-installed bushings with optimized stiffness to inhibit noise, and all necessary hardware is included.
Signs this control arm assembly may need replacing include clunking over bumps, steering wander, uneven front tire wear, or a loose, worn ball joint. Material and heat treatment are selected to meet application requirements for enhanced structural strength.
This part cross-references / interchanges with the following part numbers:
520-079, CB98003PR, CB98003, CMS95126, 104157000B
Frequently Asked Questions
Which vehicles does the MOOG RK624114 fit?
It is a direct-fit replacement for the 2014-2023 Tesla S and 2016-2023 Tesla X. Check the Buyer's Guide tab to confirm the correct application for your specific vehicle.
What position on the vehicle is this control arm for?
The RK624114 is the front left lower forward unit. It installs in the front left lower forward position on the listed applications.
Does this assembly include the ball joint and mounting hardware?
Yes. The ball joint is integrated into the assembly, and MOOG includes all necessary hardware for installation.
What are signs this control arm may need replacing?
Common signs include clunking over bumps, steering wander, uneven front tire wear, or a loose or worn ball joint. Have the cause diagnosed, since these symptoms can have other sources.
What interchange numbers does the RK624114 replace?
It cross-references 520-079 (520079), CB98003PR, CB98003, CMS95126, and 104157000B.
Write a Review
MOOG Chassis Products
MOOG Chassis Products Suspension Control Arm and Ball Joint Assembly P/N:RK624114
MOOG RK622166 Front Right Upper Suspension Control Arm and Ball Joint Assembly for Dodge ChargerFront Right Upper Suspension Control Arm and Ball Joint AssemblyMOOG premium control arms for foreign...
MOOG RK622159 Front Right Lower Suspension Control Arm and Ball Joint Assembly for Nissan SentraMOOG premium control arms for foreign and domestic nameplates are engineered for structural strength...
MOOG RK621297 Front Left Lower Suspension Control Arm and Ball Joint Assembly for Suzuki AerioFront Left Lower Suspension Control Arm and Ball Joint AssemblyMOOG premium control arms for foreign and...
MOOG RK623686 Front Left Lower Rearward Suspension Control Arm and Ball Joint Assembly for Mercedes-Benz C300Front Left Lower Rearward Suspension Control Arm and Ball Joint AssemblyMOOG premium...
MOOG RK623717 Front Left Lower Suspension Control Arm and Ball Joint Assembly for Honda FitFront Left Lower Suspension Control Arm and Ball Joint AssemblyMOOG premium control arms for foreign and...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
