Delphi Steering Center Link P/N:TL448
Keep the steering geometry tight and the ball studs turning smoothly with the Delphi Steering Center Link TL451, a direct-fit FRONT steering component for the 1995 and 1997-2001 BMW 740i, the 1995-2001 BMW 740iL, and the 1995-2001 BMW 750iL. The center link is the central bar of the steering linkage, tying the pitman arm and idler arm to the tie rods so driver input is passed evenly to both front wheels; worn ball joints in a center link can show up as loose or wandering steering, uneven tire wear, or a clunk when turning.
Delphi applies its OE steering expertise to this aftermarket part, backing it with extensive dimensional and material analysis for close OE-to-aftermarket compatibility.
Delphi includes the necessary accessories for a complete job. See the Buyer's Guide tab for engine-level fitment details.
Interchange: 3221 1091 913 · 3221 1091 917 · 3221 1093 433 · 3221 1096 057 · 101-5025
32211091913 · 32211091917 · 32211093433 · 32211096057 · 1015025 · CD02005 · CL14019 · CL14019PR · DS80674A · DS2001 · MDS80674A · MS10901 · JTY130
This part cross-references / interchanges with the following part numbers:
What is a steering center link and what does it do?
It is the central bar of the front steering linkage, connecting the pitman arm and idler arm to the tie rods so steering input is transmitted evenly to both front wheels.
Which vehicles does the Delphi TL451 fit?
It fits the 1995 and 1997-2001 BMW 740i, the 1995-2001 BMW 740iL, and the 1995-2001 BMW 750iL. Check the Buyer's Guide tab to confirm your vehicle.
What are the signs a center link may need replacing?
Loose, wandering, or sloppy steering, uneven front tire wear, and clunking through the linkage can indicate worn center-link ball joints. Diagnose the cause before replacing.
Does this part include mounting accessories?
Delphi includes the necessary accessories for a complete job. Consult the vehicle service information for the correct torque and installation procedure.
How is the Delphi TL451 protected against durability and corrosion issues?
The ball studs are machined to micron tolerances, the link is fatigue tested, and anti-corrosion protection is applied to each part. It is also validated below -40°C, above 120°C, and through 720 hours of salt spray.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.