Front Tie Rod End Adjusting Sleeve for 1995-2002 Ford Crown Victoria & More - Delphi TA2148

$21.99
Sold out

Vehicles this part fits

    Part number: TA2148
    UPC: 689604278321
    Condition: New
    Weight: 1.20 LBS
    Item Package Quantity: 1
    $21.99

    Out of stock

    Have questions?

    Delphi Steering Tie Rod End Adjusting Sleeve P/N:TA2148
    Delphi Steering Tie Rod End Adjusting Sleeve P/N:TA2148
    $21.99
    $21.99

    Dial in your front-end alignment and keep the tie rod assembly tight with the Delphi Steering Tie Rod End Adjusting Sleeve TA2148. This threaded sleeve joins the inner and outer tie rod ends on the front steering linkage, letting you set toe during an alignment and holding that setting under road load. It drops in as a direct-fit replacement for the 1995-2002 Ford Crown Victoria, 1995-2002 Lincoln Town Car, and 1995-2002 Mercury Grand Marquis — see the "Vehicles it fits" section for engine-level detail.

    • Built to Delphi's OE safety standards: validated for OE-level performance in extremes below -40°C and above 120°C, plus 720 hours of salt-spray exposure.
    • OE-matched dimensions: extensive dimensional and material analysis targets close compatibility between the OE and aftermarket part.
    • Fatigue tested: tested against fatigue to help avoid failure in service.
    • Anti-corrosion protection: applied to each part for corrosion prevention and improved appearance.
    • Complete job: includes the necessary accessories to finish the installation.

    Worn or seized adjusting sleeves can make alignment impossible to hold and may show as uneven tire wear or a steering pull. If a failed sleeve is the cause, this replaces it. An alignment is recommended after installation.

    Interchange: F5AZ 3310-A · F7AZ 3310-AA
    F5AZ3310A · F7AZ3310AA · S3311 · S3311PR · ES3311S · GES3311S · MES3311S · MES80579 · JSA1002

    Product information is for general reference and may contain errors. See our Disclaimer.

    This part cross-references / interchanges with the following part numbers:

    F5AZ 3310-A, F7AZ 3310-AA, S3311, S3311PR, ES3311S, GES3311S, MES3311S, MES80579, JSA1002

    Frequently Asked Questions

    What does this adjusting sleeve do?

    It threads between the inner and outer front tie rod ends, letting you rotate it to set toe during an alignment and locking that adjustment under load.

    Will it fit my vehicle?

    It's a direct-fit replacement for the 1995-2002 Ford Crown Victoria, 1995-2002 Lincoln Town Car, and 1995-2002 Mercury Grand Marquis. Check the "Vehicles it fits" section for engine-level detail.

    Do I need an alignment after installing it?

    Yes. Because the sleeve sets toe, a professional wheel alignment is recommended after installation to restore the correct front-end settings.

    Is this a front part?

    Yes, it is a front steering linkage component that connects the front tie rod ends.

    What are the signs this sleeve may need replacing?

    Seized or corroded sleeves can make it hard to hold an alignment and may contribute to uneven tire wear or a steering pull. Diagnose the cause before replacing.

    Reviews

    No reviews yet — be the first to review this product.

    Write a Review