Delphi Steering Tie Rod End Adjusting Sleeve P/N:TA2610
$10.99
(You save)
Lock in accurate front-end toe and keep the steering linkage tight with the Delphi Steering Tie Rod End Adjusting Sleeve TA2610. This threaded sleeve joins the inner and outer tie rod ends on the front steering linkage, letting a technician lengthen or shorten the tie rod assembly to set toe during a front-end alignment. It fits the 1993-1998 SAAB 900 and 1999-2003 SAAB 9-3 — see the Buyer's Guide tab for engine-level details.
OE-backed engineering: Delphi applies its OE steering expertise to its aftermarket portfolio, with extensive dimensional and material analysis for close compatibility between the OE and aftermarket part.
Tested to the extreme: validated below -40°C and above 120°C and exposed to 720 hours of salt spray for OE-level performance.
Fatigue tested to help avoid failure in service.
Anti-corrosion protection applied to each part for corrosion prevention and enhanced appearance.
Delphi includes the necessary accessories for a complete job.
Signs the original sleeve may need replacing include a corroded or seized sleeve, difficulty holding a toe setting, or uneven front tire wear. If a worn or rusted adjusting sleeve is the cause, this replaces it.
It threads between the inner and outer tie rod ends on the front steering linkage, letting you lengthen or shorten the tie rod to set front toe during an alignment.
Which vehicles does this Delphi sleeve fit?
It fits the 1993-1998 SAAB 900 and 1999-2003 SAAB 9-3. Check the Buyer's Guide tab to confirm the correct application for your vehicle.
What are signs my adjusting sleeve needs replacing?
A corroded or seized sleeve, trouble holding a toe setting, or uneven front tire wear. Diagnose the cause first, since these symptoms can have other sources.
Does it come with any hardware?
Delphi includes the necessary accessories for a complete job. Consult the vehicle service information for the correct torque and alignment procedure.
Is this part corrosion protected?
Yes. Anti-corrosion protection is applied to each part for corrosion prevention and enhanced appearance, and it is exposed to 720 hours of salt spray during testing.
Write a Review
Delphi
Delphi Steering Tie Rod End Adjusting Sleeve P/N:TA2610
Hold your front-end alignment true with the Delphi Steering Tie Rod End Adjusting Sleeve TA5553. This threaded sleeve joins the inner and outer tie rod ends and lets a technician set tie rod length...
Dial in accurate toe alignment and keep your steering linkage tight with the Delphi Steering Tie Rod End Adjusting Sleeve TA5913. This threaded sleeve connects the inner and outer tie rod ends —...
Dial in accurate front-wheel toe with the Delphi Steering Tie Rod End Adjusting Sleeve (TA5714). This front steering sleeve threads between the inner and outer tie rod ends, letting a technician...
Hold your front toe setting right where the alignment tech put it with the Delphi Steering Tie Rod End Adjusting Sleeve (TA2561). This threaded sleeve links the inner and outer tie rod ends in the...
Keep steering geometry dialed in and tie-rod components tightly joined with the Delphi Steering Tie Rod End Adjusting Sleeve (TA5453). This threaded sleeve links tie-rod ends and lets a technician...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
