Delphi Steering Tie Rod End Adjusting Sleeve P/N:TA2561
$15.99
(You save)
Hold your front toe setting right where the alignment tech put it with the Delphi Steering Tie Rod End Adjusting Sleeve (TA2561). This threaded sleeve links the inner and outer tie rod ends in the front steering linkage and lets a technician turn it to set toe during a wheel alignment. It installs as a direct-fit replacement for the 1979-1995 Toyota Pickup, 1986-1995 Toyota 4Runner, and 1993-1998 Toyota T100 — see the Buyer's Guide tab for the full engine-level list.
Tested to the extreme: Delphi applies its OE steering expertise to the aftermarket, with parts run below -40°C and over 120°C and exposed to 720 hours of salt spray, plus dimensional and material analysis for close OE-to-aftermarket compatibility.
Complete job: includes the necessary accessories to get the sleeve installed.
Fatigue tested to help avoid in-service failure.
Anti-corrosion protection applied to each part for corrosion prevention and enhanced appearance.
As a front steering-linkage component, a seized or corroded sleeve can make it impossible to adjust toe, so replacing a damaged original restores that adjustment. Interchange: 101-4463 · 101-6528 · 45465-35020 · 45465-35040 S2369 · S2369PR · ES2369S · GES2369S · MES2369S · JSA1004 · 4546039505 · 4546535030 · 1014463 · 1016528 · 4546535020 · 4546535040
This part cross-references / interchanges with the following part numbers:
It's a threaded sleeve in the front steering linkage that joins the inner and outer tie rod ends. Turning it lengthens or shortens the tie rod so a technician can set front toe during a wheel alignment.
Which vehicles does the TA2561 fit?
It's a direct-fit replacement for the 1979-1995 Toyota Pickup, 1986-1995 Toyota 4Runner, and 1993-1998 Toyota T100. Check the Buyer's Guide tab to confirm the exact fit for your vehicle.
Is this a front or rear part?
It is a front steering-linkage component.
Does it come with the parts needed to install it?
Yes. Delphi includes the necessary accessories to complete the installation of the sleeve.
What are signs the adjusting sleeve may need replacing?
A corroded or seized sleeve that won't turn can make toe adjustment difficult or impossible, and toe that drifts out of alignment or uneven tire wear can be signs to inspect the steering linkage. Diagnose the cause before replacing.
Write a Review
Delphi
Delphi Steering Tie Rod End Adjusting Sleeve P/N:TA2561
Dial in accurate front-wheel toe with the Delphi Steering Tie Rod End Adjusting Sleeve (TA5714). This front steering sleeve threads between the inner and outer tie rod ends, letting a technician...
Lock in accurate front-end toe and keep the steering linkage tight with the Delphi Steering Tie Rod End Adjusting Sleeve TA2610. This threaded sleeve joins the inner and outer tie rod ends on the...
Keep steering geometry dialed in and tie-rod components tightly joined with the Delphi Steering Tie Rod End Adjusting Sleeve (TA5453). This threaded sleeve links tie-rod ends and lets a technician...
Keep your steering linkage adjustable and your toe setting on spec with the Delphi Steering Tie Rod End Adjusting Sleeve TA5516. This threaded sleeve connects the inner and outer tie rod ends,...
Dial in your front-end toe and keep the steering linkage tight with the Delphi Steering Tie Rod End Adjusting Sleeve TA2548. The threaded sleeve connects the inner and outer tie rod ends, letting you...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
