Delphi Steering Tie Rod End Adjusting Sleeve P/N:TA5741
$44.99
(You save)
Dial in accurate toe alignment and keep the steering linkage adjustable with the Delphi Steering Tie Rod End Adjusting Sleeve (TA5741), a direct-fit replacement for the 1999-2004 Jeep Grand Cherokee. This threaded sleeve joins the inner and outer tie rod ends, and turning it changes the linkage length so a technician can set the wheel toe during an alignment. It is cataloged in the lower position.
OE-derived engineering: Delphi applies its OE steering expertise and extensive dimensional and material analysis for close compatibility between the OE and aftermarket part, with validation from below -40°C to over 120°C and 720 hours of salt-spray exposure.
Fatigue tested: tested against fatigue to help avoid failure in service.
Anti-corrosion protection: corrosion-resistant treatment applied to each part for corrosion prevention and improved appearance.
Accessories included: Delphi supplies the accessories needed to complete the job.
Signs the original sleeve may need replacing include corroded or seized adjusting threads, loose or damaged clamps, and alignment that will not stay set. If a worn or corroded sleeve is the cause of those conditions, this part replaces it. Have the wheel alignment checked after installation.
It is a threaded sleeve that joins the inner and outer tie rod ends. Turning it changes the linkage length, which lets a technician adjust the wheel toe during an alignment.
Does the Delphi TA5741 fit my vehicle?
It is a direct-fit replacement for the 1999-2004 Jeep Grand Cherokee. Confirm your specific vehicle against the Buyer's Guide tab before ordering.
What position is this sleeve cataloged for?
It is cataloged in the lower position on the listed applications.
What are signs the sleeve needs replacing?
Corroded or seized adjusting threads, loose or damaged clamps, and toe alignment that will not hold. Have the linkage diagnosed to confirm the sleeve is the cause.
Do I need an alignment after installing it?
Yes. Because the sleeve sets the wheel toe, have a wheel alignment performed after installation to set the linkage length correctly.
Write a Review
Delphi
Delphi Steering Tie Rod End Adjusting Sleeve P/N:TA5741
Dial in accurate front-wheel toe with the Delphi Steering Tie Rod End Adjusting Sleeve (TA5714). This front steering sleeve threads between the inner and outer tie rod ends, letting a technician...
Lock in accurate front-end toe and keep the steering linkage tight with the Delphi Steering Tie Rod End Adjusting Sleeve TA2610. This threaded sleeve joins the inner and outer tie rod ends on the...
Keep steering geometry dialed in and tie-rod components tightly joined with the Delphi Steering Tie Rod End Adjusting Sleeve (TA5453). This threaded sleeve links tie-rod ends and lets a technician...
Keep your steering linkage adjustable and your toe setting on spec with the Delphi Steering Tie Rod End Adjusting Sleeve TA5516. This threaded sleeve connects the inner and outer tie rod ends,...
Hold your front toe setting right where the alignment tech put it with the Delphi Steering Tie Rod End Adjusting Sleeve (TA2561). This threaded sleeve links the inner and outer tie rod ends in the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
