Delphi Steering Tie Rod End P/N:TA1145
Delphi TA1960 right outer tie rod end for the 2007-2011 Mercedes-Benz CLS550 and other vehicles links the steering linkage to the wheel. This Delphi tie rod end is also called a steering tie rod end.
Loose or wandering steering, a clunk from the steering area or uneven tire wear can mean a tie rod end is worn. Before you replace this part, rule out a worn wheel bearing, a loose ball joint and tires that are out of balance, since each can bring on similar looseness or vibration.
This part is listed for a wide range of Mercedes-Benz models, led by the 2007-2011 Mercedes-Benz CLS550, the 2007-2011 Mercedes-Benz CLS63 AMG and the 2003-2009 Mercedes-Benz E320. The 2007-2011 Mercedes-Benz CLS550 takes one on this side. This listing is one right outer tie rod end; the other side of that axle has its own part and is normally replaced at the same time. If your Mercedes-Benz is not named here, look it up in the "Vehicles it fits" section.
Interchange: 101-5808 · 612.35042 · 211 330 0203 · 211 330 24 03 · 211 330 26 03 · 211 330 28 03 · A211 330 0203 · A211 330 2403 · A211 330 2603 · A211 330 2803
ER06041 · TO28084 · ES800387 · MS10608 · JTE1005
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does the Delphi TA1960 tie rod end fit the 2007-2011 Mercedes-Benz CLS550?
Yes, Delphi TA1960 is a right outer tie rod end listed for the 2007-2011 Mercedes-Benz CLS550, which takes one on this side. For other cars, use the "Vehicles it fits" section.
Is this Delphi track rod end listed for the 2007-2011 Mercedes-Benz CLS63 AMG?
Yes. Track rod end is another name for a tie rod end, and Delphi TA1960 is listed for the 2007-2011 Mercedes-Benz CLS63 AMG in the right outer position.
Is this tie rod end for the right side or the left?
This tie rod end is the right outer. The left outer is a separate part and is ordered on its own.
How can I tell if a tie rod end is wearing out?
Loose or wandering steering, a clunk from the steering area or uneven tire wear can mean it is worn. A shop can check the joint for play safely.
How is the Delphi tie rod tested?
Delphi fatigue tests its tie rods to avoid failure. The parts are also tested below -40 degrees C and above 120 degrees C and exposed to 720 hours of salt spray.
No reviews yet — be the first to review this product.
Write a ReviewWARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.