Tighten up steering response by replacing a worn outer joint with the Delphi Steering Tie Rod End TA2624, a direct-fit outer tie rod end and a solid choice for a Dodge Charger tie rod replacement. This outer joint connects the steering linkage to the steering knuckle, transmitting steering input to the front wheel while allowing for suspension and steering movement. It fits the 2006-2010 Dodge Charger, 2000-2010 Dodge Dakota, 2000-2003 Dodge Durango, 2005-2010 Chrysler 300, 2008-2010 Dodge Challenger, 2005-2008 Dodge Magnum, 2006-2009 Mitsubishi Raider, and 2011 Ram Dakota — see the Buyer's Guide tab for engine-level details.
Delphi applies its OE steering expertise to this aftermarket unit, with dimensional and material analysis to match the original part:
- Extreme testing: validated below -40°C and above 120°C and through 720 hours of salt spray.
- Micron-tolerance ball stud: machined for durability and smooth joint operation.
- Fatigue tested to help avoid premature failure.
- Anti-corrosion protection applied to each part for corrosion prevention and appearance.
- Includes the necessary accessories for a complete job.
Signs this outer tie rod end may need replacing include loose or wandering steering, play in the linkage, uneven front tire wear, or a knocking sensation when turning. Sold individually; tie rod ends are commonly replaced in pairs, so consider ordering for both sides.
Interchange: 101-6754 · 612.67001 · 5201 3468AB · CH-T618 · 534-663
1016754 · 61267001 · 52013468AB · CHT618 · 534663 · T3571 · T3571XL · TO81095 · TO81101 · TO81102 · ES3571 · GES3571 · MES3571 · TXES3571 · 52013468AD · JTE1572
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
Is this a Delphi tie rod end that fits a 2010 Dodge Charger?
Yes. The Delphi TA2624 is a direct-fit outer tie rod end for the 2006-2010 Dodge Charger, along with several other listed applications. Check the Buyer's Guide tab to confirm your vehicle.
Is this an inner or outer tie rod end?
This is the outer tie rod end, which connects the steering linkage to the steering knuckle to transmit steering input to the front wheel.
What are the signs my tie rod end needs replacing?
Common signs include loose or wandering steering, play in the linkage, uneven front tire wear, and a knocking sensation when turning. Have the cause diagnosed before replacing.
How was this Delphi tie rod tested?
Delphi validates it below -40°C and above 120°C, exposes it to 720 hours of salt spray, and fatigue tests it. The ball stud is machined to micron tolerances for smooth operation.
Do I need to buy two?
It is sold individually. Tie rod ends are commonly replaced as a pair for balanced steering, so many buyers order one for each side.
Write a Review