Delphi Steering Tie Rod End P/N:TA3996

Be the first to review this product

$70.99

MPN: TA3996

UPC: 689604401958

Item Package Quantity: 1

Current Stock:

Quantity:

Adding to cart… The item has been added

Have questions?

Ask an Expert

Delphi Steering Tie Rod End P/N:TA3996

$70.99

Description

Tighten up loose, sloppy steering with the Delphi tie rod — Steering Tie Rod End TA3996, a front outer tie rod end that transmits steering input from the linkage to the steering knuckle. It's a direct-fit replacement for the 2023 Lexus RX350, 2023 Lexus RX350H, 2023 Lexus RX500H, and the 2020-2024 Toyota Highlander (see the Buyer's Guide tab for engine-level fitment).

OE-derived engineering: Delphi applies its OE steering expertise to the aftermarket portfolio, backed by extensive dimensional and material analysis for close compatibility between the OE and replacement part.
Tested to the extreme: Validated below -40°C and above 120°C and exposed to 720 hours of salt spray.
Micron-tolerance ball stud: The ball stud is machined to micron tolerances for durability and smooth joint operation, and the unit is fatigue tested.
Anti-corrosion protection is applied to each part for corrosion prevention and enhanced aesthetics.

Delphi includes the necessary accessories for a complete job. Worn tie rod ends can show up as steering play, wandering, or uneven tire wear; if a failed outer tie rod end is the cause, this part replaces it.

Interchange: 544-484 · 45460-09370
544484 · 4546009370 · ES801595 · MS866103

Manufacturer's Description

Product Specs

Buyer's Guide

Interchange Part Numbers

This part cross-references / interchanges with the following part numbers:

544-484, ES801595, MS866103, 45460-09370

Frequently Asked Questions

What is the DELPHI tie rod end TA3996?

It's a front outer steering tie rod end that transmits steering input from the linkage to the steering knuckle, helping keep your steering tight and responsive.

What vehicles does this tie rod end fit?

It's a direct-fit replacement for the 2023 Lexus RX350, RX350H and RX500H, and the 2020-2024 Toyota Highlander. Check the Buyer's Guide tab for engine-level fitment.

How is this Delphi part tested for durability?

Delphi fatigue tests the unit and validates it below -40 degrees C, above 120 degrees C, and through 720 hours of salt spray, with dimensional and material analysis for OE-level compatibility.

What are signs my tie rod end may need replacing?

Common signs include play or looseness in the steering, wandering, or uneven tire wear. Diagnose the cause first; if a failed outer tie rod end is responsible, this replaces it.

Does this DELPHI tie rod end include installation accessories?

Yes. Delphi includes the necessary accessories for a complete job. Consult the vehicle service information for correct torque specs and alignment after installation.