Keep steering tight and suspension movement controlled with the Delphi ball joint TC3396, a front lower joint that drops in as a direct-fit replacement across a range of Mercedes-Benz sedans and coupes: the 2015-2017 CLS400, 2012-2018 CLS550, 2012-2013 CLS63 AMG, 2014-2016 E250, 2010-2016 E350, 2013-2016 E400, 2010-2011 E550, and 2010-2013 E63 AMG. See the Buyer's Guide tab for engine-level details on the full list.
A ball joint links the control arm to the steering knuckle, allowing the wheel to pivot and travel while the suspension carries load. If a worn joint is behind clunking over bumps, loose or wandering steering, or uneven tire wear, this Delphi unit replaces it.
- OE-derived durability: built with Delphi's OE safety expertise; tested below -40°C and above 120°C and through 720 hours of salt spray, with dimensional and material analysis for aftermarket-to-OE compatibility.
- High-quality forgings: forged for added strength and smooth joint operation.
- Chloroprene rubber boot: improves durability and helps prevent premature failure.
- Micron-tolerance machining: machined to micron tolerances for durability and smooth movement, with anti-corrosion protection applied for corrosion prevention and enhanced appearance.
Interchange: 101-7331 · 212 330 01 35 · A 212 330 01 35
1017331 · 2123300135 · A2123300135 · BJ28325 · BJ28325PR · K500409 · MS10573
This part cross-references / interchanges with the following part numbers:
101-7331, KBJ4223, BJ28325, BJ28325PR, K500409, 212 330 01 35, A 212 330 01 35, MS10573
