Delphi Suspension Ball Joint P/N:TC1621
Built to let the front suspension travel and the wheel steer as designed, the Delphi Suspension Ball Joint (TC4298) is a Delphi ball joint made as a direct-fit front lower replacement for the listed applications. It fits many vehicles, among them the 1997-2001 Honda CR-V, 1992-2000 Honda Civic and 1993-1997 Honda Civic Del Sol; see the Buyer's Guide tab for the full list. It connects the front lower control arm to the steering knuckle, letting the suspension travel and the wheel steer while helping locate the knuckle.
Delphi applies its OE safety technology, fitted to millions of vehicles worldwide, to its aftermarket steering portfolio. Parts are tested to extremes, withstanding temperatures below -40°C and over 120°C plus 720 hours of salt spray, with extensive dimensional and material analysis for OE-to-aftermarket compatibility. If a worn ball joint is behind your clunking, loose steering or uneven front tire wear, this replaces it. See the Buyer's Guide tab for engine-level fitment.
Interchange: 101-3789 · 533-381 · 51220-S04-003 · 51220-S74-E00
1013789 · 533381 · 51220S04003 · 51220S74E00 · K9802 · MK9802 · X17BJ6832
This part cross-references / interchanges with the following part numbers:
Is this Delphi part the right Honda Civic ball joint for a 1992-2000 Honda Civic?
Yes. TC4298 is listed as a front lower ball joint for the 1992-2000 Honda Civic. See the Buyer's Guide tab for the full list of vehicles.
Does this fit a 1997-2001 Honda CR-V?
Yes, TC4298 is listed for the 1997-2001 Honda CR-V. It is a front lower ball joint; see the Buyer's Guide tab for the full list of vehicles.
What does a ball joint do and when should it be replaced?
It links the front lower control arm to the steering knuckle, allowing suspension travel and steering. Clunking, loose or wandering steering and uneven tire wear can be signs a ball joint may need replacing.
What material is the boot made of?
This Delphi ball joint uses a chloroprene rubber boot, which improves durability and helps prevent premature failure by protecting the joint.
Should I replace both sides at once?
This ball joint is sold individually, and the listed applications use two. Replacing both sides together is recommended for balanced handling; have your suspension inspected to diagnose which parts need replacing.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.