Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC1346
$116.99
(You save)
Restore precise wheel location and smooth, controlled steering with the Delphi control arm and ball joint assembly (TC1346), a direct-fit replacement for the rear left upper rearward position on the 2000-2006 BMW X5. Built on Delphi's OE safety technology fitted to millions of vehicles worldwide, this control arm and ball joint assembly combines the arm and its integrated ball joint into one serviceable unit that locates the suspension and lets the joint articulate through travel.
OE-validated durability: Delphi tests to the extreme — parts withstand temperatures below -40°C and over 120°C and endure 720 hours of salt spray, with extensive dimensional and material analysis for the best OE-to-aftermarket compatibility.
100% inspected: Every control arm undergoes crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball studs: The ball studs are machined to micron tolerances for durability and smooth joint operation.
Robot-welded, corrosion-protected: Robot welding delivers consistent quality, and anti-corrosion protection is applied to each part for corrosion prevention and enhanced appearance.
A worn BMW X5 control arm bushing or a failing ball joint can cause clunking over bumps, uneven tire wear, or loose, wandering steering; if a worn assembly in this rear upper position is the cause, this unit replaces it. Diagnose the source before ordering to confirm this rearward position matches your vehicle.
It's a control arm and ball joint assembly for the rear left upper rearward position on the 2000-2006 BMW X5, combining the control arm and its integrated ball joint into one serviceable unit.
Which vehicles does the Delphi control arm fit?
It's a direct-fit replacement for the 2000-2006 BMW X5. Check the Buyer's Guide tab to confirm the fit for your specific model.
What are signs this part may need replacing?
Clunking over bumps, uneven tire wear, or loose, wandering steering can point to a worn control arm bushing or ball joint. Diagnose the cause before replacing, as other parts can produce similar symptoms.
How is this Delphi assembly built for durability?
Delphi machines the ball studs to micron tolerances, uses robot welding, and applies anti-corrosion protection. Every arm also gets 100% crack detection and ultrasonic flaw detection to match OE specifications.
Should I replace both sides at once?
Suspension components on both sides wear at similar rates, so inspect the matching part on the opposite side and replace it if worn for balanced handling.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC1346
Sharpen wheel location and quiet worn-joint noise with the Delphi control arm and ball joint assembly, MPN TC8063 — a rear left upper unit that installs as a direct-fit replacement for the listed...
Steer with confidence and quiet the front suspension with the Delphi Control Arm with Ball Joint TC5025, a front left upper control arm and ball joint assembly. This Ford Fusion control arm installs...
Sharpen your front-end feel with this Delphi control arm (MPN TC4692), a front right upper control arm and ball joint assembly that installs as a direct-fit replacement for the 2018-2023 BMW M5, the...
Restore precise steering and quiet wheel control with the Delphi control arm, part number TC1482 — a front right lower rearward suspension control arm and ball joint assembly that installs as a...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
