Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC1411
$85.99
(You save)
Keep your front wheel located and your steering tracking straight with the Delphi Suspension Control Arm and Ball Joint Assembly (TC1411) — a front lower Ford Fusion control arm that installs as a direct-fit replacement for the 2006-2007 Ford Fusion, 2006-2007 Mercury Milan, 2007 Lincoln MKZ, 2006 Lincoln Zephyr, and 2003-2008 Mazda 6. This front lower unit connects the suspension to the chassis, while its integrated ball joint lets the wheel steer and move through its travel.
OE-focused engineering: Delphi applies its OE steering expertise to the aftermarket, with parts validated from below -40°C to over 120°C and through 720 hours of salt spray, plus dimensional and material analysis for close OE-to-aftermarket compatibility.
100% inspected: every arm undergoes crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball studs: the ball studs are machined to micron tolerances for durable, smooth joint operation.
Built and protected: robot welding for consistent quality, with anti-corrosion protection applied to each part for corrosion prevention and enhanced appearance.
If a worn control arm bushing or ball joint on your Mazda 6 or Fusion is the cause of clunking over bumps, loose or wandering steering, or uneven tire wear, this assembly replaces the failed original.
Frequently Asked Questions
Does this Delphi control arm fit my vehicle?
It's a direct-fit replacement for the 2006-2007 Ford Fusion, 2006-2007 Mercury Milan, 2007 Lincoln MKZ, 2006 Lincoln Zephyr, and 2003-2008 Mazda 6. See the Buyer's Guide tab to confirm your exact application.
Is this a front lower control arm?
Yes. TC1411 is cataloged as a front lower control arm and ball joint assembly, with the ball joint already integrated into the arm.
What does a Mazda 6 control arm do?
It locates the front lower suspension against the chassis and, through its integrated ball joint, allows the wheel to steer and move through its suspension travel.
How many should I order?
It's sold individually, so this listing is for one side. These install as left/right pairs, so order 2 to replace both sides for balanced suspension response.
What affects Ford Fusion control arm replacement cost?
Total Ford Fusion control arm replacement cost depends on shop labor and whether you replace one side or both; this listing covers the Delphi part for a single side.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC1411
The Delphi control arm TC5177 pairs the lower control arm and ball joint in one front-left assembly, giving the 2004-2009 Nissan Quest a factory-style pivot point that locates the wheel and lets the...
Locate and support your front wheel with the Delphi control arm TC6248, a FRONT RIGHT UPPER control arm and ball joint assembly built as a direct-fit replacement for the 2005-2006 Ford Expedition and...
Keep the rear suspension properly located with the Delphi TC7868, a rear upper Honda Accord control arm built as a direct-fit replacement for the 1998-2002 Honda Accord, 2001-2003 Acura CL and...
Keep your Audi's front suspension located and steering-true with the Delphi control arm and ball joint assembly (TC801). This is the front left upper rearward arm, a direct-fit replacement that pairs...
Restore precise steering and a solid front end with the Delphi control arm TC802, a direct-fit replacement control arm and ball joint assembly for the front right upper rearward position on a wide...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
