Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC802
$49.99
(You save)
Restore precise steering and a solid front end with the Delphi control arm TC802, a direct-fit replacement control arm and ball joint assembly for the front right upper rearward position on a wide range of Audi and Volkswagen models. It fits the 1996-2009 Audi A4 and A4 Quattro, the 1998-2005 Volkswagen Passat, the 1998-2004 Audi A6 and A6 Quattro, and more — see the Buyer's Guide tab for the full list.
OE-level testing: withstands temperatures below -40°C and above 120°C, endures 720 hours of salt-spray exposure, and passes dimensional and material analysis for OE compatibility.
100% inspected: every arm undergoes crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball studs: machined to micron tolerances for durability and smooth joint operation.
Built to last: robot-welded for consistent quality, with anti-corrosion protection applied for corrosion prevention and enhanced appearance.
The control arm locates and supports the wheel through its range of motion while the integrated ball joint lets the steering and suspension pivot. Signs the part may need replacing include clunking, steering wander, or uneven tire wear; if the arm or ball joint is the cause, this assembly replaces both in one unit.
Frequently Asked Questions
What position does the Delphi TC802 fit?
It is the front right upper rearward control arm for the listed Audi and Volkswagen applications. Check the Buyer's Guide tab to confirm your exact vehicle and engine.
Does this work as an Audi A4 control arm?
Yes. As an Audi A4 control arm it fits the 1996-2009 A4 and A4 Quattro, and it also fits several other Audi models plus the Volkswagen Passat.
Will it fit a vw Passat control arm application?
Yes, it fits the 1998-2005 Volkswagen Passat. As a Passat control arm it installs in the front right upper rearward position.
What are the signs this part may need replacing?
Common signs include clunking over the front suspension, steering wander, looseness, or uneven tire wear. Diagnose the cause before replacing, as these symptoms can have other sources.
Does it include corrosion protection?
Yes. Delphi applies anti-corrosion protection to each part for corrosion prevention and enhanced appearance.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC802
Shopping for a Honda Civic control arm? The Delphi Suspension Control Arm and Ball Joint Assembly (TC1075) is a front right upper unit that installs as a direct-fit replacement on the 1996-2000 Honda...
Keep your front suspension located and tracking properly with the Delphi Suspension Control Arm and Ball Joint Assembly TC1043 — a Honda Accord control arm built with Delphi's OE steering expertise...
Steer straight and keep your front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly, TC3751 — a direct-fit Honda Civic control arm that drops into the front left lower...
Sharpen loose, wandering steering with the Delphi Suspension Control Arm and Ball Joint Assembly TC5364 — a 350Z lower control arm that installs in the front right lower rearward position on the...
Delphi control arm engineering comes to your BMW's rear suspension with the Delphi Suspension Control Arm and Ball Joint Assembly (TC2954). It installs as a direct-fit replacement for the rear left...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
