Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5177
Help keep the front suspension of your Mercedes-Benz located and aligned with the Delphi control arm — the Suspension Control Arm and Ball Joint Assembly TC1496. This is the front left lower rearward arm with the ball joint pre-installed, so it locates the wheel, sets alignment geometry, and carries the lower joint in one direct-fit unit. It fits many vehicles, among them the 2006 Mercedes-Benz S350, 2000-2006 Mercedes-Benz S430 and 2000-2006 Mercedes-Benz S500; see the Buyer's Guide tab for the full list.
Delphi brings its OE expertise to this assembly:
Signs the original may need replacing include clunking on acceleration, braking, or over bumps, loose steering, and uneven tire wear at that corner. Confirm the cause before replacing.
Interchange: 101-6149 · 102-6149 · 220 330 7707 · 220 330 81 07 · 220 330 89 07 · A 220 330 43 07 · A220 330 7707 · A 220 330 81 07 · A220 330 8907
1016149 · 1026149 · 2203307707 · 2203308107 · 2203308907 · A2203304307 · A2203307707 · A2203308107 · A2203308907 · 520979 · KSC5437 · CB28293 · CB28293PR · CK620208 · RK620208 · 2203304307 · CMS101212 · CMS10137 · GS101212 · GS10137 · MS10137 · JTC1105
This part cross-references / interchanges with the following part numbers:
What position does the Delphi TC1496 control arm fit?
It is the front left lower rearward control arm with the ball joint already installed, sold as a single assembly.
Is this a 2000-2006 Mercedes-Benz S430 control arm?
Yes. It is listed for the 2000-2006 Mercedes-Benz S430, as well as the 2006 Mercedes-Benz S350 and 2000-2006 Mercedes-Benz S500. See the Buyer's Guide tab for the full list.
Does the ball joint come attached?
Yes. The ball joint is pre-installed in the arm, so you replace both as one unit rather than pressing in a separate joint.
What are signs this control arm may need replacing?
Clunking on acceleration, braking, or over bumps, loose or wandering steering, and uneven tire wear at that corner. Diagnose the cause before replacing.
How is the Delphi TC1496 tested for quality?
Delphi runs 100% crack and ultrasonic flaw detection, machines the ball stud to micron tolerances, and tests to OE standards through extreme temperatures and 720 hours of salt spray.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.