Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5177
Keep the front wheel securely located and steering tight with the Delphi control arm (TC2737), a front left lower suspension control arm and ball joint assembly that drops in as a direct-fit replacement for the 2011-2016 Hyundai Elantra, 2013-2017 Hyundai Elantra GT, 2012-2017 Hyundai Veloster, and 2013-2014 Hyundai Elantra Coupe. Combining the arm and its integrated ball joint in one unit, it locates the wheel and allows controlled suspension travel while the joint permits steering and ride motion.
If a worn front left lower control arm or ball joint is behind clunking over bumps, uneven tire wear, or loose steering on your Hyundai Elantra, this assembly replaces it. Diagnose the cause before ordering.
Interchange: 102-7582 · 102-7785 · 102-7805 · 622.51009 · 520-379 · 522-823 · 54500-3X000 · 54500-3X700 · 54500-3Y000
1027582 · 1027785 · 1027805 · 62251009 · 520379 · 522823 · 545003X000 · 545003X700 · 545003Y000 · 545002V000 · CB60303 · CB60303PR · CB60423 · CB60423PR · CK622232 · K622232 · RK622232 · CMS861116 · CMS901104 · GS861116 · JTC2744
This part cross-references / interchanges with the following part numbers:
What vehicles does the Delphi TC2737 control arm fit?
It's a direct-fit replacement for the 2011-2016 Hyundai Elantra, 2013-2017 Elantra GT, 2012-2017 Veloster, and 2013-2014 Elantra Coupe. See the Buyer's Guide tab to confirm your vehicle.
Where does the Delphi TC2737 install on the vehicle?
It is cataloged as the front left (driver-side) lower position. It combines the control arm and its integrated ball joint in a single unit.
Is the ball joint included or sold separately?
The ball joint is integrated into this assembly, so the arm and joint replace together as one unit with ball studs machined to micron tolerances.
What are the signs my Hyundai Elantra needs a lower control arm?
Clunking over bumps, uneven tire wear, or loose or wandering steering may point to a worn control arm or ball joint. Have the cause diagnosed before replacing.
How is this Delphi control arm protected against corrosion?
Anti-corrosion protection is applied to the part for corrosion prevention and appearance, and it's validated through 720 hours of salt-spray exposure to Delphi's OE testing.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.