Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC2921
$65.99
(You save)
Help tighten up your front end with the Delphi control arm with ball joint TC2921, a front right upper unit engineered to drop in as a direct-fit replacement for the 1997-2001 Honda CR-V. This control arm connects the front suspension to the chassis and locates the wheel through its travel, while the integrated ball joint allows the suspension and steering to articulate smoothly.
Tested for OE performance: withstands temperatures below -40°C and over 120°C plus 720 hours of salt spray, with extensive dimensional and material analysis for OE-to-aftermarket compatibility.
Inspected to OE specifications: 100% crack detection and ultrasonic flaw detection confirm the materials match OE specifications.
Precision ball stud: machined to micron tolerances for durability and smooth joint operation.
Robot-welded and corrosion-protected: robot welding for consistent quality, plus anti-corrosion protection applied to each part for corrosion prevention and enhanced appearance.
Signs the original may be worn include clunking over bumps, loose or wandering steering, and uneven tire wear. Fits the 1997-2001 Honda CR-V — see the Buyer's Guide tab to confirm your engine and options.
Will this Delphi control arm fit my 1997-2001 Honda CR-V?
Yes. TC2921 is a direct-fit front right upper control arm with ball joint for the 1997-2001 Honda CR-V. Check the Buyer's Guide tab to confirm your engine and options.
What does this control arm and ball joint assembly do?
It connects the front suspension to the chassis and locates the wheel through its travel, while the integrated ball joint lets the suspension and steering articulate.
Does this include the ball joint?
Yes. The ball joint is integrated into this assembly, so you replace the arm and joint together as one pre-assembled unit.
What are signs this part may need replacing?
Clunking or knocking over bumps, loose or wandering steering, uneven or premature tire wear, and vibration can be signs a worn control arm or ball joint may need replacing.
Should I replace both sides?
This listing is for one front right upper assembly. Suspension parts wear together, so inspect the opposite side and replace it if worn for balanced handling.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC2921
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Help keep steering tight and suspension geometry accurate with the Delphi control arm and ball joint assembly (TC6341), a front left lower unit that installs as a direct-fit replacement for the...
Firm up steering and restore control on your truck with the Delphi Suspension Control Arm and Ball Joint Assembly (TC6246), a direct-fit Ram 1500 lower control arm for the 2002-2005 Dodge Ram 1500...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
