Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC6341
$291.99
(You save)
Help keep steering tight and suspension geometry accurate with the Delphi control arm and ball joint assembly (TC6341), a front left lower unit that installs as a direct-fit replacement for the 2006-2011 Ford Crown Victoria and 2006-2011 Mercury Grand Marquis. Delphi applies its OE expertise to its aftermarket steering portfolio, and this arm locates the wheel while providing the lower pivot point through its integrated ball joint.
Tested to the extreme: withstands temperatures below -40°C and over 120°C and endures 720 hours of salt spray, with extensive dimensional and material analysis for close OE-to-aftermarket compatibility.
100% inspected: every arm undergoes crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball studs: machined to micron tolerances for durability and smooth joint operation.
Robot-welded & protected: robot welding delivers consistent quality, and anti-corrosion protection is applied to each part for corrosion prevention and enhanced aesthetics.
If a worn front left lower arm or ball joint is the cause, signs such as clunking over the front suspension, uneven tire wear, or loose, wandering steering may point to it. This control arm ships as a single front left lower assembly for that corner.
It's a direct-fit front left lower control arm with ball joint for the 2006-2011 Ford Crown Victoria and 2006-2011 Mercury Grand Marquis. See the Buyer's Guide tab to confirm your engine.
What position does the TC6341 cover?
This is the front left (driver-side) lower control arm and ball joint assembly.
Is the ball joint included with this control arm?
Yes. The ball joint is integrated into the assembly, so you replace the arm and its lower pivot as a single unit.
What are the signs this control arm with ball joint may need replacing?
Clunking over the front suspension, uneven or accelerated tire wear, and loose or wandering steering can indicate a worn arm or ball joint. Diagnose the cause before replacing.
Should I replace both sides at once?
This listing covers the front left lower corner only. Replacing the opposite side at the same time is good practice for balanced, even handling; order the matching right-side unit if needed.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC6341
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Steer straight and keep the front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly (TC3986), a direct-fit Tacoma lower control arm for the 2016-2022 Toyota Tacoma. It...
The Delphi control arm TC5177 pairs the lower control arm and ball joint in one front-left assembly, giving the 2004-2009 Nissan Quest a pivot point that locates the wheel and lets the suspension...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
