Delphi TC3005 front right upper control arm with ball joint for the 2005-2009 Land Rover LR3 links the suspension to the chassis. This Delphi control arm is also called a control arm and ball joint assembly, because the joint comes attached.
- Control arm withstands temperatures below -40 degrees C and over 120 degrees C and is exposed to 720 hours of salt spray
- 100% crack detection and ultrasonic flaw detection on every control arm
- Ball studs machined to micron tolerances for durability and smooth joint operation
- Robot welding for consistent performance and quality
- Anti-corrosion protection applied to each part
Quick facts
- Part: Delphi TC3005 control arm with ball joint
- Also called: control arm and ball joint assembly
- Fits: 2005-2009 Land Rover LR3
- Position: Front right upper
- Condition: New
A clunk over bumps, uneven tire wear or loose, wandering steering can mean a worn arm or ball joint. Worn bushings, shocks, tie rod ends or sway bar links can be behind those signs too, so find the cause before buying.
Fits
This arm is a direct-fit replacement for the 2005-2009 Land Rover LR3, which takes one on the front right upper position. This listing is a single arm; the front left upper is a separate part, and the other side of that axle is normally replaced at the same time.
Specifications
Fit and size
- Position: front right upper
- Quantity per vehicle: 1
Build and materials
- Type: control arm with ball joint, sold as one assembly
- Corrosion protection: anti-corrosion protection on each part
- Condition: New
Interchange: 521-864 · RBJ 500222
CB35038 · CB35038PR · K622628 · RK622628 · CMS101223
This part cross-references / interchanges with the following part numbers:
521-864, CB35038, CB35038PR, K622628, RK622628, CMS101223, RBJ 500222
Frequently Asked Questions
Does this front right upper LR3 control arm fit the 2005-2009 Land Rover LR3?
Yes. Delphi TC3005 is a direct-fit replacement for the 2005-2009 Land Rover LR3 on the front right upper position.
Is the ball joint included with the Delphi TC3005 control arm?
Yes. Delphi TC3005 is an assembly, so the ball joint comes attached to the arm.
Does this control arm have rust protection?
Yes. Anti-corrosion protection is applied to each part, and the parts are exposed to 720 hours of salt spray.
How is this control arm checked for flaws?
Every arm goes through 100% crack detection and ultrasonic flaw detection. The ball studs are machined to micron tolerances.
What temperatures can this control arm with ball joint take?
These parts withstand temperatures below -40 degrees C and over 120 degrees C.
