Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3250
$105.99
(You save)
Keep the front-right suspension precisely located with the Delphi control arm TC3250, a front right lower control arm and ball joint assembly that installs as a direct-fit replacement for the 2013-2014 Buick Encore. It positions the wheel and connects the suspension to the steering knuckle through an integrated ball joint, so a worn original can be swapped in one part.
Built to Delphi OE standards: validated to the extremes for OE performance, withstanding temperatures below -40°C and over 120°C plus 720 hours of salt spray, with extensive dimensional and material analysis for OE-to-aftermarket compatibility.
100% inspected: each arm undergoes crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball studs: machined to micron tolerances for durable, smooth joint operation.
Robot-welded with anti-corrosion protection: consistent welds plus anti-corrosion protection applied to each part for corrosion prevention and enhanced aesthetics.
If a worn ball joint or a worn original front right lower arm is behind clunking over bumps, loose or wandering steering, or uneven tire wear, this assembly replaces it. Sold individually; replacing the opposite side at the same time is recommended for a matched pair and balanced handling.
Does this control arm fit a 2013-2014 Buick Encore?
Yes. It is listed as a direct-fit replacement for the 2013-2014 Buick Encore. Confirm your exact vehicle in the Buyer's Guide tab.
What position is the TC3250 control arm?
It is the front right lower control arm with an integrated ball joint. It locates the wheel and connects the suspension to the steering knuckle.
What are signs I may need to replace this control arm?
Clunking over bumps, loose or wandering steering, and uneven tire wear can be signs of a worn ball joint or control arm. Diagnose the cause first; if this arm is at fault, replacing it addresses it.
Do I need to replace both sides?
This listing is for the front right lower side, sold individually. Replacing both left and right as a matched pair is recommended for even, balanced handling, but not required.
What quality checks does Delphi apply to this part?
Delphi applies its OE expertise, testing to extremes with 720 hours of salt spray, 100% crack and ultrasonic flaw detection, and micron-tolerance ball studs for OE-level quality.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3250
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
