Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC6234
Keep the front suspension located and the steering knuckle pivoting smoothly with the Delphi control arm and ball joint assembly TC3341. This front upper unit installs as a direct-fit replacement across a broad range of BMW models, including the 2011-2016 528I, 2011-2016 535I, 2010-2017 535I GT, 2012-2018 640I, 2012-2018 650I, 2009-2012 750I and the 2011-2012 Alpina B7 — see the Buyer's Guide tab for the full 36-application list.
Delphi applies its OE steering expertise to this aftermarket assembly, with extensive dimensional and material analysis for close OE-to-aftermarket compatibility.
The arm locates the wheel while the integrated ball joint lets the steering knuckle pivot and travel with the suspension. If a worn arm or joint is the cause of loose steering or a front-end clunk, this assembly replaces both in one piece.
Interchange: 3112 6779 908 · 102-7554 · 526-936
31126779908 · 1027554 · 526936 · CB14026 · CB14026PR · RK621905 · CMS101356
This part cross-references / interchanges with the following part numbers:
Where is this control arm located on the vehicle?
It is a front upper control arm with an integrated ball joint. The arm locates the wheel while the ball joint lets the steering knuckle pivot and move with the suspension travel.
Does the TC3341 fit my BMW?
It's a direct-fit replacement for many 2009-2020 BMW models, including the 528I, 535I, 640I, 650I, 750I and Alpina variants. Check the Buyer's Guide tab for the full application list.
What are the signs this part may need replacing?
Common signs include clunking or knocking from the front suspension, loose or wandering steering, vibration, and uneven front tire wear. Have the cause diagnosed before replacing.
Is the ball joint included with this arm?
Yes. The ball joint is integrated into this assembly, so the arm and joint are replaced together as one unit. Delphi machines the ball studs to micron tolerances for smooth operation.
How is this Delphi part tested and protected?
Delphi applies anti-corrosion protection to each part and validates its control arms with 100% crack and ultrasonic flaw detection, plus exposure below -40C, above 120C, and 720 hours of salt spray.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.