Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3985
$92.99
(You save)
Nail down precise steering and steady wheel location with the DELPHI control arm (P/N TC3985), a front left lower control arm and ball joint assembly that drops in for the 2016-2021 Honda HR-V. Delphi applies its OE steering expertise to this aftermarket unit, with extensive dimensional and material analysis to keep the OE and aftermarket part closely matched.
Tested to the extreme: validated for OE-level performance in temperatures below -40°C and above 120°C, plus 720 hours of salt-spray exposure.
Verified integrity: 100% crack detection and ultrasonic flaw detection help confirm materials match OE specifications.
Precision ball stud: studs are machined to micron tolerances for durability and smooth joint operation.
Built for consistency: robot welding delivers repeatable quality, and anti-corrosion protection is applied to each part for corrosion prevention and enhanced appearance.
The control arm positions the wheel and, through its integrated ball joint, allows the steering knuckle to pivot and travel with the suspension. Clunking over the front end, loose or wandering steering, and uneven tire wear can be signs the original arm or ball joint may need replacing; if a worn front left lower arm is the cause, this assembly replaces it. If you're weighing DELPHI control arm reviews, this unit carries Delphi's OE-grounded engineering.
What vehicle does the DELPHI TC3985 control arm fit?
It's a direct-fit replacement for the 2016-2021 Honda HR-V. See the Buyer's Guide tab to confirm it matches your specific vehicle.
What position is this control arm and ball joint assembly?
It is the front left lower control arm with an integrated ball joint for the listed Honda HR-V applications.
What does this control arm do?
It locates the wheel and, through its integrated ball joint, lets the steering knuckle pivot and move with the suspension while helping maintain alignment.
What are signs my control arm or ball joint may need replacing?
Clunking over the front end, loose or wandering steering, and uneven tire wear can indicate a worn arm or ball joint. Diagnose the cause before replacing.
How is this Delphi control arm built and protected?
Studs are machined to micron tolerances, arms are robot-welded and undergo 100% crack and ultrasonic flaw detection, and anti-corrosion protection is applied to each part.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3985
Suspension Control Arm and Ball Joint AssemblyDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio...
Suspension Control Arm and Ball Joint AssemblyDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio...
Suspension Control Arm and Ball Joint AssemblyDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio...
Suspension Control Arm and Ball Joint AssemblyDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
