Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5326
$100.99
(You save)
Restore precise wheel location and steering feel with the Delphi control arm and its integrated ball joint, MPN TC5326 — a direct-fit front right lower control arm and ball joint assembly for the 2005-2010 Chevrolet Cobalt, 2008-2010 Chevrolet HHR, 2007-2010 Pontiac G5, 2005-2006 Pontiac Pursuit and 2003-2007 Saturn Ion. The arm positions the wheel and reacts road loads, while the pressed-in ball joint lets the steering knuckle pivot through steering and suspension travel.
OE-validated engineering: Delphi applies its OE steering expertise to the aftermarket, testing to extremes — below -40°C and above 120°C, plus 720 hours of salt spray — with dimensional and material analysis for close OE-to-aftermarket compatibility.
100% flaw inspection: Every arm gets crack detection and ultrasonic flaw detection so materials match OE specifications.
Micron-machined ball studs: Studs are machined to micron tolerances for durability and smooth joint operation.
Robot-welded & corrosion-protected: Robotic welding gives consistent quality, and an anti-corrosion treatment is applied for corrosion prevention and improved appearance.
Whether you're shopping a chevy Cobalt lower control arm — including the 2007 Cobalt — or an Hhr control arm, this assembly bolts in to replace a worn or failed original.
It's a direct-fit front right lower unit for the 2005-2010 Chevrolet Cobalt, 2008-2010 Chevrolet HHR, 2007-2010 Pontiac G5, 2005-2006 Pontiac Pursuit and 2003-2007 Saturn Ion. See the Buyer's Guide tab to confirm your vehicle.
What position on the vehicle is this control arm for?
This assembly is cataloged for the front right (passenger-side) lower position on the listed applications.
Does this assembly include the ball joint?
Yes. This is a control arm and ball joint assembly, so the ball joint comes pre-installed in the arm — no separate joint to buy or press in.
What are signs my control arm or ball joint may need replacing?
Common signs include clunking over bumps, loose or wandering steering, and uneven front tire wear. Have the suspension inspected; if a worn arm or ball joint is the cause, this assembly replaces it.
Is this a chevy Cobalt lower control arm for a 2007 model?
Yes. The 2007 Chevrolet Cobalt falls within the covered 2005-2010 Cobalt range, so this front right lower assembly applies to that year.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5326
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
