Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5758
$110.99
(You save)
Steer with confidence on the Delphi control arm and integrated ball joint, part number TC5758. This front right lower control arm and ball joint assembly drops in as a direct-fit replacement for the 2002-2008 Jaguar X-TYPE, locating the wheel while the pressed-in ball joint lets the knuckle pivot and travel with the suspension. Delphi builds on its OE experience for the aftermarket steering and suspension line, and every arm is validated against the original for close dimensional and material compatibility.
Tested to extremes: engineered for OE performance below -40°C and above 120°C, with 720 hours of salt-spray exposure.
Verified materials: 100% crack detection and ultrasonic flaw detection help the material match OE specifications.
Precision ball stud: the stud is machined to micron tolerances for durability and smooth joint operation.
Robot-welded & protected: robotic welding for consistent quality, plus anti-corrosion protection applied for corrosion prevention and enhanced appearance.
Signs the original control arm or ball joint may need replacing include clunking over bumps or during steering, uneven tire wear, wander, and loose or vague handling. Replacing a worn front lower arm restores proper wheel location and joint articulation when that component is the cause.
What vehicle does the Delphi TC5758 control arm and ball joint assembly fit?
It is a direct-fit replacement for the 2002-2008 Jaguar X-TYPE. See the Buyer's Guide tab to confirm the exact application for your vehicle.
Which position is this Jaguar X-type control arm?
It is the front right lower control arm with an integrated ball joint for the listed X-TYPE applications.
Does this assembly include the ball joint?
Yes. The ball joint is built into the assembly, so you replace the arm and joint as one unit with the studs machined to micron tolerances.
What are signs my control arm or ball joint needs replacing?
Common signs include clunking over bumps or when steering, uneven tire wear, steering wander, and loose or vague handling. Diagnose the cause before replacing.
How is this Delphi control arm protected against corrosion?
Anti-corrosion protection is applied to each part for corrosion prevention and enhanced appearance, and Delphi validates it with 720 hours of salt-spray testing.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5758
The Delphi control arm TC5177 pairs the lower control arm and ball joint in one front-left assembly, giving the 2004-2009 Nissan Quest a factory-style pivot point that locates the wheel and lets the...
Locate and support your front wheel with the Delphi control arm TC6248, a FRONT RIGHT UPPER control arm and ball joint assembly built as a direct-fit replacement for the 2005-2006 Ford Expedition and...
Restore precise wheel location and quiet handling on your Honda Accord control arm job with the Delphi Suspension Control Arm and Ball Joint Assembly (TC7868). This rear upper control arm and ball...
Keep your Audi's front suspension located and steering-true with the Delphi control arm and ball joint assembly (TC801). This is the front left upper rearward arm, a direct-fit replacement that pairs...
Restore precise steering and a solid front end with the Delphi control arm TC802, a direct-fit replacement control arm and ball joint assembly for the front right upper rearward position on a wide...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
