Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC2874
Locate the rear wheel and keep the ball joint working smoothly with the DELPHI control arm, part number TC6000. This is the rear right lower unit, and it installs as a direct-fit replacement for the 2009-2012 Ford Escape and 2009-2011 Mercury Mariner.
Delphi draws on its OE steering and suspension expertise for this aftermarket assembly, using extensive dimensional and material analysis for close compatibility between the OE and aftermarket part.
Worn control arms and ball joints often show up as clunking, loose steering, or uneven tire wear; if the original arm or its integrated ball joint is the cause, this assembly replaces it. It is sold individually, and replacing both sides together is recommended where these arms install as a left/right pair.
Interchange: 522-320 · 9L8Z 5500-C
522320 · 9L8Z5500C · CB85534 · CB85534PR · RK621455 · RK621663 · CMS40155 · GS40155 · JTC2886
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What is the Delphi TC6000 control arm and ball joint assembly?
It's a rear right lower suspension control arm with an integrated ball joint that locates the wheel and allows suspension travel. It replaces the original worn arm and joint as a single assembly.
Does the TC6000 fit my 2009-2012 Ford Escape?
Yes, it's a direct-fit replacement for the 2009-2012 Ford Escape and 2009-2011 Mercury Mariner. See the "Vehicles it fits" section to confirm your exact vehicle.
Which position is this control arm?
This is the rear right lower unit, sold individually. Where the arms install as a left/right pair, replacing both sides together is recommended.
What signs suggest I need this part?
Clunking over the rear suspension, loose or wandering steering, and uneven tire wear may be signs of a worn control arm or ball joint. Diagnose the cause before replacing.
How is the Delphi TC6000 built for durability?
Delphi machines the ball studs to micron tolerances, uses robot welding for consistency, and applies anti-corrosion protection. Parts are validated below -40°C, above 120°C, and through 720 hours of salt spray.
No reviews yet — be the first to review this product.
Write a ReviewWARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.