Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC1075
Delphi TC3085 front right lower control arm with ball joint for the 2014-2016 Mercedes-Benz E250 and other vehicles holds the front right wheel to the suspension and lets it move up and down. Sold as a control arm and ball joint assembly, it replaces the arm and the joint in one piece.
A clunk over bumps, loose steering or uneven tire wear can mean this arm or its ball joint is worn, though a worn tie rod end or sway bar link can be behind the same signs. Front arms are normally replaced as a pair, so plan on the left side too; this listing is one arm, for the front right.
This control arm also fits the 2013-2015 Mercedes-Benz E400 and the 2011-2013 Mercedes-Benz E350; the front right on these cars calls for just one. If your car is not named here, run it through the "Vehicles it fits" section.
Fit and size
Build and materials
Interchange: 102-7530 · 522-714 · 212 330 28 11 · A212 330 2811
KSC5338 · CB28118 · CB28264 · CK621956 · K621956 · RK621956 · CMS101072 · CMS101200 · JTC2197
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this Mercedes E350 control arm correct for the 2011-2013 model years?
Yes. Delphi TC3085 is the front right lower control arm with ball joint for the 2011-2013 Mercedes-Benz E350, and that side takes one. For a different car, look it up in the "Vehicles it fits" section.
Does this Delphi control arm come with the ball joint?
Yes. Delphi TC3085 is an assembly with the ball joint built into the arm, and its ball studs are machined to micron tolerances.
What temperature and salt spray testing do these control arms go through?
Delphi TC3085 withstands temperatures below -40 degrees C and over 120 degrees C and is exposed to 720 hours of salt spray in testing. Anti-corrosion protection is applied to each part.
What signs can show a worn lower control arm with ball joint?
A clunk over bumps, loose steering or uneven tire wear can point to wear here. A shop can check the joint for play and the arm for cracks.
How are these Delphi control arms checked for flaws?
Each Delphi control arm goes through 100% crack detection and ultrasonic flaw detection. The arms are also robot welded for consistent quality.
No reviews yet — be the first to review this product.
Write a ReviewWARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.