Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC1075

Help bring back a steady, connected feel to the front end by replacing a worn 1996-2000 Honda Civic control arm with the Delphi TC1075, a front right upper control arm with ball joint that installs as a direct-fit replacement for that car and the 1997-2000 Acura EL. See the Buyer's Guide tab for engine-level fitment.

This control arm and ball joint assembly combines both parts in one piece. It links the steering knuckle to the chassis and lets the wheel travel with the suspension while it steers. Delphi uses dimensional and material analysis to support close compatibility between this aftermarket part and the original.

• OE-level testing: Delphi brings its original-equipment safety expertise to its aftermarket steering line. Parts are tested at temperatures below -40°C and above 120°C and through 720 hours of salt spray.
• Inspected and robot-welded: Every Delphi control arm goes through 100% crack detection and ultrasonic flaw detection to confirm the materials meet OE specifications. Robotic welding is used for consistent performance and quality.
• Precision ball studs: The ball studs are machined to micron tolerances, designed for durability and smooth joint operation.
• Anti-corrosion protection: Anti-corrosion protection is applied to each part for corrosion prevention and a clean finish.

This Delphi control arm is cataloged for the front right upper position. Clunking over bumps, loose or wandering steering, and uneven tire wear are signs this part may need replacing. Other steering and suspension components can cause the same symptoms, so diagnose the cause before replacing. Follow the vehicle service information for fasteners and torque values, and have a wheel alignment done after installation.