Delphi control arm engineering comes to your BMW's rear suspension with the Delphi Suspension Control Arm and Ball Joint Assembly (TC2954). It installs as a direct-fit replacement for the rear left position on a wide range of BMW cars, including the 2008-2010 BMW 528I, locating the wheel while the integrated ball joint allows the controlled movement your suspension and steering need.
Worn suspension components can show up as clunking or knocking over bumps, loose or wandering steering, and uneven tire wear; if a failed rear left control arm or its ball joint is the cause, this assembly replaces it. Inspect the matching side and related suspension parts, and have an alignment performed after installation.
Fitment: a direct-fit replacement for the 2002-2005 BMW 745I, 2004-2007 BMW 530I, 2005-2007 BMW 525I, 2006-2010 BMW 550I, 2008-2010 BMW 535I, and more — see the Buyer's Guide tab for the full list and engine details.
Interchange: 33 30 6 772 241 · 3332 2347 991 · 3332 6758 141 · 3332 6767 759 · 3332 6769 971 · 33 32 6 770 775 · 3332 6774 793 · 518 429 24 S2 · 101-5027 · 102-5027 · 102-7748 · 521-497
33306772241 · 33322347991 · 33326758141 · 33326767759 · 33326769971 · 33326770775 · 33326774793 · 51842924S2 · 1015027 · 1025027 · 1027748 · 521497 · CB14527 · CK620136 · K620136 · RK620131 · RK620136 · CMS101020 · MS101244 · JTC1122
This part cross-references / interchanges with the following part numbers:
Will this Delphi control arm fit my BMW 528I?
Yes, TC2954 is a direct-fit replacement for the rear left position on the 2008-2010 BMW 528I, plus the 528I xDrive and many other BMW models. Check the Buyer's Guide tab to confirm your year and model.
What position on the vehicle does TC2954 cover?
It is cataloged for the rear left suspension position. Confirm the exact corner against the Buyer's Guide tab for your specific BMW.
What are the signs my control arm or ball joint needs replacing?
Common signs include clunking or knocking over bumps, loose or wandering steering, and uneven tire wear. Have the cause diagnosed, since these symptoms can come from other suspension parts too.
Is this a complete control arm and ball joint assembly?
Yes, TC2954 combines the control arm with an integrated ball joint machined to micron tolerances, so you replace both as a single unit.
What do the Delphi control arm reviews and testing cover?
Delphi validates its parts with 100% crack and ultrasonic flaw detection, temperature testing from below -40°C to over 120°C, and 720 hours of salt spray for OE-level compatibility.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
