Locate the front wheel, control suspension travel, and carry the integrated ball joint with the Delphi Suspension Control Arm and Ball Joint Assembly (TC6352), a front left lower unit for the driver's side. It's a direct-fit replacement for the 2007-2013 Acura MDX and 2010-2013 Acura ZDX — see the Buyer's Guide tab for engine-level details.
Signs this part may need replacing include clunking on acceleration, deceleration, or over bumps, loose or wandering steering, and uneven tire wear. Replace as a set with the opposite side when worn for balanced handling; have an alignment performed after installation.
Interchange: 102-7543 · 521-893 · 51360-STX-A07
1027543 · 521893 · 51360STXA07 · CB50073 · CB50073PR · RK622037 · CMS601025 · GS601025
This part cross-references / interchanges with the following part numbers:
What vehicles does the Delphi TC6352 fit?
It's a direct-fit replacement for the 2007-2013 Acura MDX and 2010-2013 Acura ZDX. Check the Buyer's Guide tab to confirm the fit for your specific vehicle.
What position is this control arm?
This is the front left (driver's side) lower control arm and ball joint assembly. Order the matching side for your vehicle.
Does it include the ball joint?
Yes. The ball joint is integrated into this control arm assembly, so you replace the arm and joint together as one unit.
What are the signs this control arm needs replacing?
Clunking on acceleration, deceleration, or over bumps, loose or wandering steering, and uneven tire wear can indicate a worn control arm or ball joint. Diagnose the cause before replacing.
Do I need an alignment after installing it?
Yes, a wheel alignment is recommended after replacing a control arm to restore proper suspension geometry and protect tire wear.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
