Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC994
Delphi TC6392 front right lower control arm with ball joint for the 2012-2018 Audi A6 and other vehicles connects the wheel to the suspension and pivots at its ball joint. This control arm and ball joint assembly comes as one piece, so the arm and the joint are replaced together.
A clunk over bumps, loose or wandering steering, or uneven tire wear can mean a worn control arm or ball joint. Other suspension parts can produce similar symptoms, so with the engine off, look the arm over for cracks, rust or damage, and leave play checks to a shop. If this arm or joint is the cause, this assembly replaces both.
It works as a lower control arm for the 2012-2018 Audi A6 and also fits the 2012-2018 Audi A6 Quattro and the 2012-2018 Audi A7 Quattro. Delphi runs dimensional and material analysis against the OE part for compatibility. If your Audi is a different model, look it up in the "Vehicles it fits" section.
Fit and size
Build and materials
One front right lower control arm with ball joint. This listing is one piece; the front right lower rearward position takes one, the left side is a separate part, and both sides are normally replaced together.
Interchange: 102-8002 · 522-954
4G0 407 694 F · 4G0 407 694 H · 4G0 407 694 J · 4G0407694L · KSC4334 · CB12254 · CB12254PR · RK622833 · CMS70175
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Will this Audi A6 control arm fit a 2012-2018 Audi A6?
Yes. Delphi TC6392 fits the 2012-2018 Audi A6; for other Audi models, look yours up in the "Vehicles it fits" section.
Is this suspension arm right for the 2012-2018 Audi A6 Quattro?
Yes. Delphi TC6392 fits the 2012-2018 Audi A6 Quattro, and it is the front right lower rearward arm.
How is the Delphi TC6392 control arm tested for cold, heat and salt?
Delphi tests this control arm at temperatures below -40 degrees C and over 120 degrees C and exposes it to 720 hours of salt spray. Anti-corrosion protection is applied to each part.
Why does my front end clunk over bumps, and could it be the ball joint?
A clunk over bumps can come from a worn control arm or ball joint, but other suspension parts can cause it too. A shop can measure play and show which part is worn.
Does Delphi TC6392 replace Audi number 4G0 407 694 J?
Yes. Delphi TC6392 is listed as a replacement for 4G0 407 694 J, one of the cross-reference numbers on this page.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.