Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC8161
Give your front suspension a fresh pivot point with the Delphi TC816 Control Arm with Ball Joint, a front left upper control arm that is a direct-fit replacement for the 1992-1995 Honda Civic, 1993-1997 Honda Civic Del Sol and 1994-2001 Acura Integra. The arm links the steering knuckle to the chassis, and its integrated ball joint pivots as the wheel steers and moves through its suspension travel. See the "Vehicles it fits" section for engine and trim details.
This Delphi control arm draws on the company's OE safety expertise, which is fitted to millions of vehicles worldwide and carried into its aftermarket steering portfolio. Delphi tests its parts to the extreme: at temperatures below -40°C and above 120°C, and through 720 hours of salt spray exposure. Extensive dimensional and material analysis is aimed at close compatibility between the OE part and the aftermarket part.
Signs that a control arm and ball joint assembly may need replacing include clunking over bumps, loose or wandering steering, uneven tire wear and play at the ball joint. This listing covers the left side. Replacing the matching right-side arm at the same time is recommended, and the wheel alignment should be checked after installation.
Product information is for general reference and may contain errors. See our Disclaimer.
Will this control arm fit a 1992-1995 Honda Civic?
Yes. The TC816 is listed for the 1994-2001 Acura Integra, the 1992-1995 Honda Civic and the 1993-1997 Honda Civic Del Sol. See the "Vehicles it fits" section for engine and trim details.
Which position is this control arm for?
It is cataloged for the front left upper position. Replacing the right-side upper arm at the same time is recommended so both sides are matched.
What does an upper control arm with ball joint do?
It links the steering knuckle to the vehicle's chassis. The wheel can move up and down while the ball joint pivots as you steer.
What signs may mean the control arm needs replacing?
Clunking over bumps, loose or wandering steering, uneven tire wear or play in the ball joint may indicate a worn arm. Have the suspension inspected to confirm the cause before replacing parts.
How does Delphi test the TC816?
Delphi reports testing below -40°C and above 120°C, plus 720 hours of salt spray exposure. Each control arm also goes through 100% crack detection and ultrasonic flaw detection.
No reviews yet — be the first to review this product.
Write a ReviewWARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.