Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC8188
$211.99
(You save)
Keep your front end tight and your steering precise with the Delphi Suspension Control Arm and Ball Joint Assembly (TC8188) — a direct-fit Nissan Altima control arm that locates the front wheel and carries an integrated ball joint. It installs in the front right lower position on the 2015-2018 Nissan Altima and the 2016-2023 Nissan Maxima (see the Buyer's Guide tab for engine-level fitment). This control arm and ball joint assembly brings Delphi's OE engineering to the aftermarket, so the geometry matches what left the factory.
Tested to the extreme: validated below -40°C and above 120°C and put through 720 hours of salt spray, with dimensional and material analysis for close OE-to-aftermarket compatibility.
Verified materials: 100% crack detection and ultrasonic flaw detection confirm the material matches OE specifications.
Precision ball studs: machined to micron tolerances for durability and smooth joint operation.
Robot-welded & protected: robotic welding for consistent quality, plus anti-corrosion protection applied to each part for corrosion prevention and improved appearance.
If a worn lower control arm Nissan Altima owners battle — or a failing joint on your Nissan Maxima control arm — is behind clunks, loose steering, or uneven tire wear, this DELPHI control arm replaces it.
What vehicles does the Delphi TC8188 control arm fit?
It's a direct-fit front right lower control arm and ball joint assembly for the 2015-2018 Nissan Altima and the 2016-2023 Nissan Maxima. See the Buyer's Guide tab for engine-level fitment.
Which position does TC8188 install in?
It's cataloged for the front right lower position. Confirm the corner you need before ordering, as this listing covers that specific location.
Does this assembly include the ball joint?
Yes. The ball joint is integrated into the control arm assembly, with ball studs machined to micron tolerances for durability and smooth joint operation.
What are signs my control arm or ball joint may need replacing?
Common signs include clunking over bumps or during turns, loose or wandering steering, and uneven tire wear. Have the cause diagnosed, since these symptoms can have other sources.
How is this Delphi control arm protected against corrosion?
Anti-corrosion protection is applied to each part for corrosion prevention and improved appearance, and Delphi validates parts through 720 hours of salt spray testing.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC8188
Keep your front suspension located and your steering geometry tight with the Delphi control arm, MPN TC2044 — a front right upper forward control arm and ball joint assembly built with Delphi's OE...
Shopping for a Honda Civic control arm? The Delphi Suspension Control Arm and Ball Joint Assembly (TC1075) is a front right upper unit that installs as a direct-fit replacement on the 1996-2000 Honda...
Keep your front suspension located and tracking properly with the Delphi Suspension Control Arm and Ball Joint Assembly TC1043 — a Honda Accord control arm built with Delphi's OE steering expertise...
Steer straight and keep your front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly, TC3751 — a direct-fit Honda Civic control arm that drops into the front left lower...
Sharpen loose, wandering steering with the Delphi Suspension Control Arm and Ball Joint Assembly TC5364 — a 350Z lower control arm that installs in the front right lower rearward position on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
