Help tighten up worn, sloppy steering with the Delphi control arm and ball joint assembly, MPN TC854 — a front right lower unit that locates the wheel and lets it pivot through steering and suspension travel. It installs as a direct-fit replacement for the 1995-1998 Nissan 200SX and the 1995-1999 Nissan Sentra; see the "Vehicles it fits" section for engine-level applications.
- Delphi OE engineering: built on Delphi's OE steering expertise, with extensive dimensional and material analysis for close compatibility between the OE and aftermarket part.
- Tested to the extreme: withstands temperatures below -40°C and over 120°C and endures 720 hours of salt spray.
- Quality-verified: 100% crack detection and ultrasonic flaw detection help the materials match OE specifications, with robot welding for consistent build.
- Smooth joint operation: ball studs machined to micron tolerances; anti-corrosion protection applied to each part.
A worn control arm or ball joint can show up as clunking over bumps, uneven tire wear, or wandering steering. If a failed original is the cause, this lower control arm for the 1995-1999 Nissan Sentra and 1995-1998 Nissan 200SX replaces the arm and ball joint as one unit. Consult the vehicle service information for the correct fasteners and whether they may be reused.
Interchange: 101-5160 · 102-5160 · 54500-0M010 · 54500-0M020 · 54500-0M060 · 54500-F4300 · 520-524 · 523-661
1015160 · 1025160 · 545000M010 · 545000M020 · 545000M060 · 54500F4300 · 520524 · 523661 · BJ69285 · BJ69285XL · CB30420 · CB30420PR · KSC5669 · CK620357 · K620357 · RK620357 · CMS3061 · GS3061 · MS3061 · JTC565
This part cross-references / interchanges with the following part numbers:
101-5160, 102-5160, 54500-0M010, 54500-0M020, 54500-0M060, 54500-F4300, 520-524, 523-661, BJ69285, BJ69285XL, CB30420, CB30420PR, KSC5669, CK620357, K620357, RK620357, CMS3061, GS3061, MS3061, JTC565
Frequently Asked Questions
What vehicles does the Delphi TC854 control arm fit?
It's a direct-fit replacement for the 1995-1998 Nissan 200SX and the 1995-1999 Nissan Sentra. Check the "Vehicles it fits" section for engine-level applications.
What position is this control arm and ball joint assembly?
It is the front right lower control arm with an integrated ball joint for the listed applications.
Does it come with the ball joint installed?
Yes. The ball joint is part of the assembly, so you replace the control arm and joint together as one unit.
What are the signs my control arm or ball joint may need replacing?
Clunking over bumps, uneven tire wear, or wandering steering can indicate a worn arm or joint. Have the cause diagnosed before replacing.
Are mounting fasteners included?
Consult the vehicle service information for the correct fasteners and whether they may be reused, since some suspension hardware is single-use.
