Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC8823
$416.99
(You save)
Keep your Land Rover's front suspension tight and precisely located with the Delphi control arm and ball joint assembly, part number TC8823. It drops in as a direct-fit replacement for the front left lower position on the 2020-2024 Land Rover Discovery Sport and 2020-2024 Land Rover Range Rover Evoque (All engines), combining the lower control arm and its integrated ball joint in a single bolt-in unit. This DELPHI control arm carries the same OE safety engineering Delphi builds into millions of factory-fitted parts.
Tested to OE extremes: validated across temperatures below -40°C to over 120°C and through 720 hours of salt-spray exposure, with dimensional and material analysis for close OE compatibility.
100% inspected: every arm undergoes full crack detection and ultrasonic flaw detection so its materials match OE specifications.
Precision ball stud: the ball stud is machined to micron tolerances for durable, smooth joint operation.
Robot-welded & protected: consistent robotic welding plus anti-corrosion protection that helps prevent corrosion and improves appearance.
Signs the original may need replacing include clunking or knocking over bumps, loose or wandering steering, and uneven front tire wear; if a worn control arm or ball joint is the cause, this assembly replaces both at once. Sold individually. Country of origin: Turkey.
This part cross-references / interchanges with the following part numbers:
LR114249, LR146038, LR166007, X25CJ1496
Frequently Asked Questions
What is the Delphi TC8823 assembly?
It is the front left lower suspension control arm with its ball joint integrated into a single bolt-in unit for the listed Land Rover applications.
Which vehicles does this DELPHI control arm fit?
The 2020-2024 Land Rover Discovery Sport and 2020-2024 Land Rover Range Rover Evoque (All engines). Check the Buyer's Guide tab to confirm your vehicle.
What position is this for?
The front left (driver's side) lower position. It is sold individually; the right side uses a separate mirror-image part.
What are signs my control arm may need replacing?
Clunking or knocking over bumps, loose or wandering steering, and uneven front tire wear. Diagnose the cause first, since other parts can produce similar symptoms.
How is this part tested?
Delphi runs 100% crack and ultrasonic flaw detection, machines the ball stud to micron tolerances, and validates parts across extreme temperatures and 720 hours of salt spray.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC8823
Steer straight and keep your front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly, TC3751 — a direct-fit Honda Civic control arm that drops into the front left lower...
Steady your steering and locate the front wheel with the DELPHI control arm and ball joint assembly TC6265, a direct-fit replacement for the front right lower position on the 2001 Chrysler Sebring,...
Keep your rear suspension tracking straight with the DELPHI control arm and ball joint assembly, part number TC7277. It's the rear right upper unit for the 2004-2009 Nissan Quest, pairing the control...
Get precise steering and secure wheel location with the Delphi control arm and ball joint assembly TC763, the front right lower unit for the 1985-1987 Volkswagen Golf and Jetta. This is a Delphi...
Keep the front suspension properly located and pivoting smoothly with the Delphi control arm, MPN TC6663 — a front left lower control arm and ball joint assembly that pairs the arm with its...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
