Delphi Suspension Control Arm Bushing P/N:TD1061W
Delphi TD1631W rear lower control arm bushing for the 2004-2013 Mazda 3 and other vehicles cushions the control arm's mounting point.
A clunk over bumps, rear-end wander or uneven rear tire wear can mean a worn suspension control arm bushing, though a tired rear shock absorber or a rear wheel bearing can be behind them too. Find the cause before you replace anything.
It fits the 2004-2013 Mazda 3 and the 2009-2013 Mazda 3 Sport, which take two per car, and it is designed to OE standards. This listing is one bushing, and the other side of the rear axle is normally replaced at the same time.
Fit and size
Build and materials
Interchange: 102-5910 · 521-337 · 521-416 · BBM2-28-500A
CA85575 · CA85575PR · CK660012 · RK660012 · CMS76110
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this a control arm bushing for the 2004-2013 Mazda 3?
Yes. Delphi TD1631W is a rear lower forward control arm bushing that fits the 2004-2013 Mazda 3.
Is this a control arm bushing replacement for the 2009-2013 Mazda 3 Sport?
Yes. Delphi TD1631W also fits the 2009-2013 Mazda 3 Sport, in the same rear lower forward position.
What is the Delphi TD1631W bushing made of?
Delphi TD1631W is a rubber bushing and is installed with a press fit.
How can I tell a rear control arm bushing is worn?
A worn bushing can show up as a clunk over bumps, rear-end wander or uneven rear tire wear. If you notice these, have a shop inspect the rear suspension.
Does this bushing replace part number 521-337?
Yes. 521-337 is one of the numbers Delphi TD1631W replaces, along with 102-5910 and 521-416.
No reviews yet — be the first to review this product.
Write a ReviewWARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.