Front Lower Control Arm Bushing for 1999-2004 Honda Odyssey - Delphi TD1488W

$16.99
WARNING:California Proposition 65▾
Delphi Suspension Control Arm Bushing TD1488W
Delphi Suspension Control Arm Bushing TD1488W

Vehicles this part fits
    Part number: TD1488W
    UPC: 689604270301
    Condition: New
    Weight: 0.90 LBS
    Item Package Quantity: 1
    $16.99
    Adding to cart… The item has been added

    Have questions?

    Ask an Expert
    Delphi Suspension Control Arm Bushing P/N:TD1488W
    Delphi Suspension Control Arm Bushing P/N:TD1488W
    $16.99
    $16.99

    Help quiet down clunks and keep your suspension steady with the Delphi Suspension Control Arm Bushing TD1488W, a direct-fit 1999-2004 Honda Odyssey control arm bushing. It seats in the front lower rearward control arm position, cushioning the arm at the chassis so the suspension can move as intended while isolating road noise and vibration.

    • Built to OE standards: Delphi applies its OE engineering to the aftermarket steering portfolio, backed by extensive dimensional and material analysis for close compatibility between the original and replacement part.
    • Tested to the extreme: validated below -40°C and above 120°C and subjected to 720 hours of salt spray for OE-level performance.
    • Consistent, quiet ride: manufactured for consistent life and engineered to reduce noise and vibration.
    • Complete job: Delphi includes the necessary accessories.

    A cracked, dry-rotted, or split bushing can allow excess movement, producing clunks over bumps or during braking and acceleration; if a worn front lower rearward bushing is the cause, this replaces it. Diagnose the source before ordering.

    Interchange: 101-6458 · 602.4001 · 51393-S0X-A02
    1016458 · 6024001 · 51393S0XA02 · BU05004 · BC59280 · BC59280PR · K200002 · K200788 · GK200002 · MK200002 · JBU1510 · JBU850

    Product information is for general reference and may contain errors. See our Disclaimer.

    This part cross-references / interchanges with the following part numbers:

    101-6458, 602.4001, 51393-S0X-A02, BU05004, BC59280, BC59280PR, K200002, K200788, GK200002, MK200002, JBU1510, JBU850

    Frequently Asked Questions

    What vehicles does the Delphi TD1488W bushing fit?

    It is a direct-fit control arm bushing for the 1999-2004 Honda Odyssey. See the "Vehicles it fits" section to confirm the fit for your specific vehicle.

    Where does this bushing install?

    It seats in the front lower rearward control arm position, cushioning the arm where it mounts to the chassis.

    What are the signs I may need a control arm bushing replacement?

    A cracked or dry-rotted bushing, clunking over bumps, or movement during braking and acceleration can point to a worn bushing. Diagnose the cause before replacing.

    Is this a genuine Delphi part built to OE standards?

    Yes. Delphi designs its bushings to OE standards and validates them below -40°C, above 120°C, and through 720 hours of salt spray.

    Does it come with the hardware needed for the job?

    Delphi includes the necessary accessories for the installation. Consult the vehicle service information for the correct fasteners and whether they may be reused.

    Reviews

    No reviews yet — be the first to review this product.

    Write a Review

    Related Products

    !