Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4566W
$18.99
(You save)
Keep the front stabilizer bar firmly located and help quiet suspension rattle with the Delphi Suspension Stabilizer Bar Bushing Kit (TD4566W). This front sway bar bushing kit installs as a direct-fit replacement for the 1994-2001 Dodge Ram 1500, 1994-2004 Dodge Ram 2500, 1994-2004 Dodge Ram 3500, 1997-2004 Dodge Dakota, 1999-2003 Dodge Durango, 1997-2006 Jeep Wrangler, and 1997-2006 Jeep TJ.
The rubber bushings cushion and locate the front stabilizer bar against the chassis as the bar works to limit body roll, isolating vibration and helping keep the bar from knocking against its mounts.
Built to OE standards: Delphi applies its OE steering and suspension expertise to this aftermarket bushing kit.
Tested to the extreme: validated at temperatures below -40°C and above 120°C, plus 720 hours of salt-spray exposure.
Made for consistent life: manufactured for durable, repeatable performance and to help reduce noise.
Ride quality: designed to help restore the vehicle's smooth ride when worn bushings are the cause.
Delphi's dimensional and material analysis targets close compatibility between the OE and aftermarket part.
It supplies replacement rubber bushings that cushion and locate the front stabilizer (sway) bar against the chassis, isolating vibration and helping reduce noise while the bar limits body roll.
Which vehicles does this kit fit?
It's a direct-fit replacement for the 1994-2001 Dodge Ram 1500, 1994-2004 Dodge Ram 2500 and 3500, 1997-2004 Dodge Dakota, 1999-2003 Dodge Durango, and 1997-2006 Jeep Wrangler and TJ. See the Buyer's Guide tab.
Is this also called a stabilizer bar bushing kit?
Yes. This part is listed as both a sway bar bushing kit and a stabilizer bar bushing kit; both names refer to the same Delphi TD4566W front bushings.
Does it fit the front or rear?
This kit is cataloged for the front stabilizer bar.
What are signs the bushings may need replacing?
Clunking, rattling, or knocking from the front stabilizer bar over bumps, along with cracked or worn rubber, may be signs the bushings need attention. Diagnose the cause before replacing.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4566W
Quiet a clunking rear sway bar and keep it located under hard cornering with the Delphi Suspension Stabilizer Bar Bushing Kit (P/N: TD4177W). This kit cushions the rear stabilizer bar where it mounts...
Keep the rear stabilizer bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit (TD5070W). These bushings secure the rear stabilizer bar to the frame, cushioning it against the...
Quiet a clunking, knocking rear sway bar and keep the stabilizer bar located properly with the Delphi Suspension Stabilizer Bar Bushing Kit (TD996W). This rear sway bar bushing kit cushions the bar...
Quiet a clunking, rattling front sway bar and help keep your Mercedes-Benz cornering flat with the Delphi Suspension Stabilizer Bar Bushing Kit TD5885W. This front-to-frame stabilizer bar bushing kit...
Quiet a clunking front sway bar and keep the stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD671W. These front stabilizer bar bushings cushion the bar...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
