Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD5888W
$18.99
(You save)
Quiet a clunking rear sway bar and firm up body control with the Delphi Suspension Stabilizer Bar Bushing Kit TD5888W. This rear stabilizer bar bushing kit drops in as a direct-fit replacement for the 2009-2011 Nissan Murano, cushioning the rear stabilizer bar where it mounts to the chassis so the bar can twist and resist body roll without metal-to-metal contact. Worn, cracked, or hardened bushings let the bar shift in its mounts — a common source of clunks or rattles over bumps and looser handling in corners.
Built to OE standards: Delphi applies its OE engineering to the aftermarket, with extensive dimensional and material analysis for close compatibility between the OE and aftermarket part.
Validated to the extreme: Delphi tests components below -40°C and over 120°C, plus 720 hours of salt-spray exposure.
Consistent, quieter service: The bushings are manufactured for consistent life and to reduce noise.
Smoother ride: Designed to help restore the vehicle's smooth ride when worn bushings are the cause.
Inspect and replace bushings in matched sets for even, balanced handling. Consult the vehicle service information for the correct fasteners and whether they may be reused.
This part cross-references / interchanges with the following part numbers:
56243-1AD0A, K201427, MS308182
Frequently Asked Questions
What vehicle does the Delphi TD5888W kit fit?
It is a direct-fit replacement for the 2009-2011 Nissan Murano. See the Buyer's Guide tab to confirm your exact vehicle and engine.
Is this a front or rear stabilizer bar bushing kit?
This is a rear kit — it replaces the bushings that mount the rear stabilizer bar to the chassis.
What are the signs my sway bar bushings may need replacing?
Clunks or rattles over bumps, increased body roll in corners, or visibly cracked and hardened bushing material can all be signs the bushings have worn.
What does a stabilizer bar bushing kit do?
The bushings cushion the stabilizer bar at its chassis mounts, letting the bar twist to resist body roll while limiting noise and metal-to-metal contact.
Are mounting fasteners included?
Consult the vehicle service information for the correct fasteners and whether they may be reused, since many chassis fasteners are single-use.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD5888W
Quiet a noisy rear stabilizer bar and keep it properly located with the Delphi Suspension Stabilizer Bar Bushing Kit TD1455W. This rear sway bar bushing kit drops in as a direct-fit replacement for...
Quiet front-end rattle and keep the stabilizer bar firmly located to the control arm with the Delphi Suspension Stabilizer Bar Bushing Kit TD4128W. It installs as a direct-fit replacement on many...
Help quiet the clunk and rattle from a loose stabilizer bar and hold it firmly to the chassis with the Delphi Suspension Stabilizer Bar Bushing Kit TD4074W. This front-to-frame sway bar bushing kit...
Help reduce front-end noise and keep your stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD4053W. This front sway bar bushing kit installs as a...
Keep the front stabilizer bar firmly located and help quiet suspension rattle with the Delphi Suspension Stabilizer Bar Bushing Kit (TD4566W). This front sway bar bushing kit fits many vehicles,...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
