Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD909W
$32.99
(You save)
Cushion the rear stabilizer bar and quiet suspension rattles with the Delphi Suspension Stabilizer Bar Bushing Kit TD909W. This rear stabilizer bar bushing kit is a direct-fit replacement for the 2003-2011 SAAB 9-3 (see the Buyer's Guide tab for engine-level fitment), locating the bar to the chassis so it can control body roll while isolating road vibration. Delphi applies its OE steering and suspension expertise to this aftermarket kit, and the bushings are designed to OE standards.
Built to OE standards: Delphi's dimensional and material analysis targets close compatibility between the OE and aftermarket part.
Tested to the extreme: Delphi validates parts below -40°C and over 120°C, plus 720 hours of salt-spray exposure.
Consistent, quieter service: the bushings are manufactured for consistent life and to reduce noise.
Ride comfort: designed to help restore the smooth ride of the vehicle when worn bushings are the cause.
Worn stabilizer bar bushings can show up as clunks or rattles over bumps and vague, sloppy handling in corners; if they are the source, this kit replaces them.
Interchange: 71740113 · 444161 · 24457386
This part cross-references / interchanges with the following part numbers:
71740113, 444161, 24457386
Frequently Asked Questions
What vehicles does the Delphi TD909W fit?
It is a direct-fit replacement for the 2003-2011 SAAB 9-3. See the Buyer's Guide tab for engine-level fitment details.
Is this a front or rear bushing kit?
This is a rear stabilizer bar bushing kit, cataloged for the rear stabilizer (sway) bar position.
What is a stabilizer bar bushing kit?
It supplies the bushings that locate the stabilizer bar to the chassis, letting the bar control body roll while isolating vibration and reducing noise.
What are signs the bushings need replacing?
Clunks or rattles over bumps and vague, sloppy handling in corners can point to worn stabilizer bar bushings. Diagnose the cause before replacing.
How is Delphi's quality validated?
Delphi tests below -40°C and over 120°C, exposes parts to 720 hours of salt spray, and uses dimensional and material analysis for OE compatibility.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD909W
Quiet a clunking rear sway bar and keep it located under hard cornering with the Delphi Suspension Stabilizer Bar Bushing Kit (P/N: TD4177W). This kit cushions the rear stabilizer bar where it mounts...
Keep the rear stabilizer bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit (TD5070W). These bushings secure the rear stabilizer bar to the frame, cushioning it against the...
Quiet a clunking, rattling front sway bar and help keep your Mercedes-Benz cornering flat with the Delphi Suspension Stabilizer Bar Bushing Kit TD5885W. This front-to-frame stabilizer bar bushing kit...
Quiet a clunking front sway bar and keep the stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD671W. These front stabilizer bar bushings cushion the bar...
Quiet a clunking front sway bar and keep the stabilizer bar properly located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD994W). It drops in as a direct-fit replacement for the front...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
