Bring firm, leak-free hydraulic clamping back to the rear of your Super Duty with the Raybestos R-Line Remanufactured Semi-Loaded Disc Brake Caliper and Bracket Assembly (FRC11963). This floating caliper installs in the rear right position as a direct-fit replacement for the 2007-2013 Ford F-250 Super Duty [All] and the 2008-2013 Ford F-350 Super Duty [All]. It arrives remanufactured from an OE core with all-new rubber and sealing components, ready to clamp the pads against the rotor when hydraulic pressure is applied.
All-new seals & hardware: seals, boots, bleeder screws, abutment hardware, banjo bolts, and O-rings are replaced with new materials for leak-free operation.
EPDM70 rubber components: for heat resistance, performance, and durability; silicone boots are used on heavy-duty applications where applicable.
Inspected & pressure tested: castings, guide pins, and brackets are carefully inspected before re-use, and each caliper is 100% pressure tested.
Specs: floating caliper, cast iron casting, 1.89 in (48 mm) piston, 3/8-24 bleeder screw thread, 16.000 mm bracket mounting hole with 2.000 mm thread pitch; materials match OE specifications.
This semi-loaded assembly includes the caliper and mounting bracket. Country of origin: Mexico.
It's cataloged for the rear right position on the 2007-2013 Ford F-250 Super Duty [All] and 2008-2013 Ford F-350 Super Duty [All]. See the Buyer's Guide tab to confirm your vehicle.
Is this a new or remanufactured caliper?
It's a Raybestos R-Line remanufactured OE unit rebuilt with all-new seals, boots, bleeder screws, abutment hardware, banjo bolts, and O-rings, then 100% pressure tested.
What are the caliper's key specs?
It's a floating caliper with a cast iron casting, a 1.89 in (48 mm) piston, a 3/8-24 bleeder screw thread, and a 16.000 mm bracket mounting hole with 2.000 mm thread pitch.
Does it include the mounting bracket?
Yes. This semi-loaded assembly includes the caliper and its mounting bracket. Brake pads are not listed among the included components.
Should I replace both rear calipers together?
This listing is for one caliper (rear right). Servicing both sides of the axle as a matched pair is recommended for even, balanced braking, though it's not strictly required.
Clamp your rear brake pads against the rotor with the Raybestos R-Line Remanufactured Semi-Loaded Disc Brake Caliper and Bracket Assembly (FRC11625) — a floating caliper rebuilt from an original OE...
Clamp the brake pads against the rotor with steady hydraulic force using the Raybestos R-Line Remanufactured Semi-Loaded Disc Brake Caliper & Bracket Assembly, MPN FRC11585. It's cataloged for the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
