Carry pressurized brake fluid to the rear left wheel with the Dorman - First Stop Brake Hydraulic Hose H38250. This flexible hose links the rigid brake line to the wheel-end brake component, flexing with suspension movement while holding line pressure. It installs as a position-specific, direct-fit replacement for the rear left position on the 1985-1990 Buick Electra, 1986-1991 Buick LeSabre, 1991 Buick Park Avenue, 1985-1991 Cadillac DeVille, 1985-1991 Cadillac Fleetwood, 1985-1991 Oldsmobile 98, 1986-1991 Oldsmobile Delta 88 and 1987-1991 Pontiac Bonneville (All engines).
- EPDM rubber build: made with EPDM rubber and a rubber outer sleeve/jacket for flexible, durable service.
- Treated-steel fittings: female fittings in treated steel with specially coated, corrosion-resistant surfaces; End 1 thread size 10 mm, End 2 fitting M10 x 1.0.
- Measured to spec: 12.25 in overall length, built to precise measurements for an exact fit and easy installation; DOT approved.
- Standards-tested: materials tested to government-regulated safety and durability standards.
No bracket, mounting hardware, or gasket/seal is included; consult the vehicle service information for the correct fasteners and whether they may be reused. Country of origin: China.
Interchange: 18J338 · 87-36323 · 8736323 · B917138 · 612203 · HB-82323 · HB82323 · 77409 · 150.62323 · 15062323 · BH177409 · 350-45024 · 35045024 · 18032049 · 25516370 · 25522287 · NF38250 · 4538250 · BH38250 · 2201168 · BH111944 · F111944. Manufacturer part number H38250.
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What does this brake hydraulic hose do?
It connects the rigid brake line to the wheel-end brake component and carries pressurized brake fluid, flexing with suspension movement while maintaining line pressure.
Which position does H38250 fit?
It is a position-specific replacement for the rear left position on the listed applications. Check the Buyer's Guide tab to confirm the fit for your vehicle.
What is the hose made of?
It is made with EPDM rubber and a rubber outer sleeve/jacket, with female fittings in treated steel that have specially coated, corrosion-resistant surfaces.
Are brackets, hardware, or gaskets included?
No. No bracket, mounting hardware, or gasket/seal is included. Consult the vehicle service information for the correct fasteners and whether they may be reused.
What are the fitting and length specs?
Overall length is 12.25 in. End 1 thread size is 10 mm and End 2 is M10 x 1.0; both ends use female fittings. The hose is DOT approved.
Write a Review