Dorman - First Stop Brake Hydraulic Hose P/N:H621789
Dorman H620654 rear left brake hydraulic hose for the 2000-2005 Toyota MR2 Spyder carries brake fluid between the hard brake line and the brake at that wheel. As a flexible hose, it lets the line move with the wheel and suspension.
A cracked, bulging or leaking hose, or a soft brake pedal, can mean a hose is worn. Before you replace this hose, rule out a leaking caliper or a loose fitting at the line, since a wet spot at the wheel can start in any of those places.
This hose fits the 2000-2005 Toyota MR2 Spyder. This listing is the rear left hose only; the rear right is a separate part, and the hoses on that axle are normally replaced at the same time.
Fit and size
Build and materials
One brake hose with gaskets and a bracket. This listing holds one hose, and the rear left of the 2000-2005 Toyota MR2 Spyder takes one. Mounting hardware is not included, so plan on new hardware, since the old pieces may not be reusable.
Interchange: 073-1754 · 150.44392
611579 · 78963 · BH381609 · 2201575 · 9094702B62 · BH144147 · F144147
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does the Dorman H620654 fit the 2000-2005 Toyota MR2 Spyder?
Yes. Dorman H620654 is the rear left brake hydraulic hose for the 2000-2005 Toyota MR2 Spyder, and the rear right side is a separate part.
Is this Dorman brake hydraulic hose made of EPDM rubber?
Yes. Dorman H620654 has an EPDM rubber hose with a rubber outer sleeve. The end fittings are treated steel with a corrosion-resistant coating.
Are gaskets and a bracket included with this rear left brake hose?
Yes. The box holds one hose with gaskets and a stamped steel bracket. Mounting hardware is not included, so plan on new hardware.
What size are the end fittings on the H620654 brake hose?
End 1 is a banjo fitting with a 10 mm thread size, and end 2 is a female fitting sized M10 x 1.0. Overall length is 16.13 inches.
How can I tell if my rear left brake hose is worn?
A cracked or bulging hose, fluid at the wheel, or a soft or low brake pedal can mean the hose is worn. A shop can inspect the hose and test the brake system, so have it looked at promptly.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.