Dorman - First Stop Drum Brake Wheel Cylinder P/N:W134494
Push the rear brake shoes firmly against the drum every time you press the pedal with the Dorman drum brake wheel cylinder from the Dorman - First Stop line, part number W37677. It fits many vehicles, among them the 1995-2002 Chevrolet Cavalier, 1992-2001 Chevrolet Lumina and 1995-1999 Chevrolet Monte Carlo. See the Buyer's Guide tab for the full list.
Dorman engineered this direct-replacement rear wheel cylinder to match the original unit's fit, function and performance on the listed applications, and it is manufactured and tested for quality assurance. When you press the brake pedal, fluid pressure from the master cylinder drives the pistons outward and forces the shoes against the drum.
Signs a wheel cylinder may need replacing include brake fluid seeping inside the drum or onto the backing plate, fluid-soaked shoes, a soft or low brake pedal, and a dropping fluid level. Diagnose the cause before replacing parts, and bleed the brake system after installation.
Interchange: 172-1539 · 172-1558 · 784-36050 · 84-36050 · 101-1495 · W-82050 · 134.62050 · 135.62050 · 375-45012
1721539 · 1721558 · 78436050 · 8436050 · 1011495 · W82050 · 13462050 · 13562050 · 37545012 · 18E1270 · 18E256 · W906575 · 33936 · 34084 · WC13936 · WC14084 · 18012582 · 18020210 · 18029869 · 18029943 · 112341 · WC370265 · F112341 · F129240 · WC112341 · WC129240
This part cross-references / interchanges with the following part numbers:
What does wheel cylinder W37677 do?
It mounts at the rear drum brake. It uses hydraulic pressure from the master cylinder to push the brake shoes outward against the drum when you press the brake pedal.
Will W37677 fit my 1995-2002 Chevrolet Cavalier?
Yes, it is listed for the 1995-2002 Chevrolet Cavalier, along with the 1992-2001 Chevrolet Lumina and 1995-1999 Chevrolet Monte Carlo. Check the Buyer's Guide tab to confirm your vehicle.
What are the cups and boots made of?
The pressure cups and boots on this wheel cylinder are made from high-quality EPDM rubber.
How are the cylinder bores checked?
The wheel cylinder bores are surface-tested to provide an optimum sealing surface for the pressure cups. The unit is also manufactured and tested for quality assurance.
Do I need to bleed the brakes after installing it?
Yes. Opening the hydraulic system lets air in, so bleed the brakes after installation. Follow the vehicle service information for the correct procedure.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.