Dorman - First Stop Drum Brake Wheel Cylinder P/N:W610187
Replace a worn or leaking rear wheel cylinder with this Dorman drum brake wheel cylinder, part number W37983 from the Dorman - First Stop line, which turns brake-fluid pressure into the force that pushes the brake shoes out against the drum. It fits many vehicles, among them the 1998-2008 Subaru Forester, 2003-2004 Subaru Outback and 1995-1999 Subaru Legacy. See the Buyer's Guide tab for the full list.
Dorman engineered this direct replacement to match the original wheel cylinder in fit, function and performance on the listed applications. Each unit is manufactured and tested for quality assurance.
Signs a wheel cylinder may need replacing include brake fluid seeping inside the drum or onto the backing plate, a soft or sinking pedal, and brakes that pull or grab. Inspect the brake system to confirm the cause before replacing parts, and bleed the brakes after installation.
Interchange: 784-18007 · 84-18007 · 101-1317 · W-55007 · 072-9128 · 134.47007 · 135.47007 · 375-13007
78418007 · 8418007 · 1011317 · W55007 · 0729128 · 13447007 · 13547007 · 37513007 · 18E392 · W906725 · 34118 · WC14118 · WC37983 · 26256AA010 · 26256AA011 · F131650 · F140948 · WC131650 · WC140948
This part cross-references / interchanges with the following part numbers:
What does a drum brake wheel cylinder do?
When you press the pedal, fluid pressure pushes the cylinder's pistons outward. The pistons force the brake shoes against the drum to slow the wheel. The W37983 is cataloged for the rear drum brakes.
Which vehicles does the Dorman W37983 fit?
It fits many vehicles, including the 1998-2008 Subaru Forester, 2003-2004 Subaru Outback and 1995-1999 Subaru Legacy. See the Buyer's Guide tab for the full list.
What are the cups and boots made of?
The W37983 uses high-quality EPDM rubber cups and boots. Its cylinder bores are surface-tested to provide an optimum sealing surface for the pressure cups.
What are signs a wheel cylinder may need replacing?
Common signs include brake fluid leaking inside the drum or onto the backing plate, a soft or sinking pedal, and brakes that pull or grab. Diagnose the cause before replacing parts.
Do the brakes need to be bled after installing it?
Yes. Opening the hydraulic line lets air into the system, so bleed the brakes after installation. Follow the vehicle service information for the procedure and torque values.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.