Dorman - OE Solutions Ignition Knock (Detonation) Sensor Kit P/N:962-702
Dorman 962-700 ignition knock (detonation) sensor kit for the 2007-2013 Chevrolet Silverado 1500 V8 4.8L, 5.3L or 6.0L, the 2009-2013 Silverado 1500 V8 6.2L and other vehicles senses engine knock and includes the wiring harness electrical connector. The sensor detects detonation in the engine so the control module can respond to it.
A check engine light with rough running can point to a failed knock sensor, though other faults cause the same signs. With the engine off and cool, look over the sensor wiring and connector for cracks, damage or corrosion, and find the cause before you replace the kit.
It also fits the 2007-2013 GMC Sierra 1500 V8 4.8L, 5.3L, 6.0L or 6.2L and the 2007-2014 Chevrolet Tahoe V8 5.3L, and each of those takes one kit. If yours is a different model, match your year and engine in the "Vehicles it fits" section.
Fit and size
Build and materials
One knock sensor, one pig tail connector, two crimp connectors and one bolt.
Interchange: 2421049 · PT2652 · S8811 · 1581267 · 1581724 · AS10261 · 2131576 · 12570125 · 12623730 · 2KNC0414 · 8125701250 · 8126237300 · ID0300 · KS211 · KS211T · S934 · 5S6712 · KNK160 · 1P1571
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does the Dorman 962-700 knock sensor kit fit the 2007-2013 Chevrolet Silverado 1500 V8 4.8L, 5.3L or 6.0L?
Yes. Dorman 962-700 fits the 2007-2013 Chevrolet Silverado 1500 V8 4.8L, 5.3L or 6.0L and the 2009-2013 Silverado 1500 V8 6.2L. For other models, see the "Vehicles it fits" section.
What is included in the Dorman 962-700 knock sensor kit?
The kit has one knock sensor, one pig tail connector, two crimp connectors and one bolt.
How long is the wiring harness on this knock sensor kit?
The wiring harness is 280 mm long and uses 18 gauge wire. It ends in a female oval connector with a plastic body.
What can a failing knock sensor cause?
A failing knock sensor can show up as a check engine light and rough running, but other faults cause the same signs. A shop can test the sensor circuit with the engine running.
Do I need to cut or splice wires to install this knock sensor kit?
No. Dorman 962-700 is plug-and-play: its harness matches the original wiring harness, so no cutting or splicing is needed.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.