Dorman - OE Solutions Ignition Knock (Detonation) Sensor Kit P/N:962-701
Dorman 962-703 ignition knock (detonation) sensor kit for the 2002-2009 Honda CR-V 4-cylinder 2.4L and other vehicles replaces a failed knock sensor and its wiring connector in one package. It is benchmarked against original components for performance and quality.
A check engine light with rough running can point to a failed knock sensor, but other faults can show up the same way. Before replacing it, look over the sensor and its harness connector for cracks, corrosion or damage with the engine off and cool; a shop can test the sensor itself.
This kit is a direct-fit replacement for the 2002-2009 Honda CR-V 4-cylinder 2.4L, the 2003-2007 Honda Accord 4-cylinder 2.4L or V6 3.0L and the 2002-2005 Honda Civic 4-cylinder 2.0L. Driving something else? Look up your car in the "Vehicles it fits" section.
Fit and size
Build and materials
One knock sensor, one pig tail connector and two crimp connectors. This listing is a single kit, and a car needs just one.
Interchange: HA1317962 · S8797 · 1580917 · AS10263 · 2KNC0006 · 30530PNA003 · 30530PPLA01 · ID0213 · KS197 · KS197T · 5S2320 · KNK149 · V26720167 · 2421056
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does the Dorman 962-703 knock sensor kit fit a 2003-2007 Honda Accord 4-cylinder 2.4L?
Yes. Dorman 962-703 is listed for the 2003-2007 Honda Accord 4-cylinder 2.4L and V6 3.0L. For another car, look it up in the "Vehicles it fits" section.
Which connectors come with this knock sensor kit?
The Dorman 962-703 kit holds one knock sensor, one pig tail connector and two crimp connectors.
What wire gauge is the harness on this knock sensor kit?
The harness uses 18 gauge wire and is 280 mm long. It has a round female connector and a male blade terminal.
Can a bad knock sensor turn on the check engine light?
Yes, a failed knock sensor can set the check engine light and make the engine run rough. A shop can test the sensor to confirm.
Do I have to cut or splice wires to install this knock sensor kit?
No. Dorman 962-703 is plug-and-play and matches the original wiring harness, so no cutting or splicing is needed.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.